IMPORTANT! | Notes: |
| If the squelch threshold is adjusted too high, the transmission range will |
| be reduced. Therefore, always adjust the squelch threshold to the lowest |
| possible setting. The squelch threshold is |
| When in the setting mode of the “SQELCH” menu, pressing the button |
| (DOWN) for more than three seconds will switch the squelch off. “SQ.OFF” |
| appears on the display. If no RF signal is being received, hissing noise will |
| occur. This setting is for test purposes only. |
| Selecting the standard display |
DISPLY | Via the “DISPLY” menu, you can select the standard display: |
Contents of standard display
selectable |
|
| SK 100 G2, SKM 100 G2, | |
Standard display | EM 100 G2 | EK 100 G2 | ||
SKP 100 G2 | ||||
|
|
| ||
„FREQ“ |
|
|
| |
„NAME“ |
|
|
| |
„CHAN“ |
| ⎯ |
|
| Entering a name |
NAME | Via the “NAME” menu, you can enter a freely selectable name for each trans- |
| mitter and receiver. You can, for example, enter the name of the performer |
| for whom the adjustments have been made. |
The name can be displayed on the standard display and can consist of up to six characters such as:
yletters (without pronounciation marks),
ynumbers from 0 to 9,
yspecial characters e.g. ()
To enter a name, proceed as follows:
Press the SET button to get into the setting mode of the “NAME” menu.
The first segment starts flashing on the display.
With the / buttons you can now select a character. By briefly pressing a button, the display jumps either forwards or backwards to the next cha- racter. If you hold down a button, the display starts cycling continuously.
Press the SET button to change to the next segment and select the next character.
Have you entered the name completely? Press the SET button to store your setting and to return to the previous menu level.
34
