Connecting the amplifier/mixing console

The EM 100 G2’s audio outputs are available as an XLR-3M socket and a ¼” (6.3 mm) jack socket , allowing you to simultaneously connect two units (e.g. amplifier, mixing console). The adjusted audio output level is com- mon for both sockets.

Connect the amplifier/mixing console to the XLR-3M socket

or the

¼” (6.3 mm) jack socket .

 

For detailed information on balanced and unbalanced connection, please refer to the section “Connector assignment” auf Seite 43.

Via the operating menu, adapt the level of the audio output (AF OUT) to the input of the amplifier or mixing console (see: „Adjusting the audio output level (receivers only)“ on page 33).

Service interface

The service interface

is only required for servicing purposes.

19” rack adapter and antenna mount (accessories)

For mounting one or two receivers into a 19” rack, you require the GA 2 rack adapter. The GA 2 rack adapter consists of:

y2 rack mount “ears”

y1 connecting bar

y1 connecting plate

y 2 covering plugs for antenna holes

y12 recessed head screws M 3x6

y2 recessed head screws M 6x10

When mounting only one receiver into a rack, you can use the AM 2 antenna mount (available as an accessory) to mount the transmitter’s antenna con- nection to the front of the GA 2 rack adapter. The AM 2 antenna mount con- sists of :

y 2 BNC extension cables (screw-in BNC socket to BNC connector )

y2 plains washers

y2 nuts

15

Page 15
Image 15
Sennheiser W100 Connecting the amplifier/mixing console, Service interface, Rack adapter and antenna mount accessories