Adjustment tips for the operating menu

Switching between channel banks

BANK

Via the “BANK” menu, you can switch between the nine channel banks of the transmitters and receivers. The channel banks “1” to “8” have four switchable channels that are factory-preset to a transmission/receiving fre- quency (see: „The channel bank system“ on page 4). The channel bank “U” (user bank) has four switchable channels to store your selection out of 1440 transmission/receiving frequencies that are freely selectable within the pre- set frequency range.

When switching from one channel bank to another, the channel with the lowest channel number is automatically displayed. If, during the last scan of this channel bank, an interfering frequency was detected on the channel with the lowest channel number (see: „Scanning the channel banks for free chan- nels (receivers only)“ on page 31), the receiver display panel automatically displays the next free channel.

Switching between the channels in a channel bank

CHAN

Via the “CHAN” menu, you can switch between the four channels in a channel bank.

Always set the transmitter and the receiver of a transmission link to the same channel. After scanning a channel bank (see: „Scanning the channel banks for free channels (receivers only)“ on page 31), only the free channels are dis- played. Set the transmitter to one of the free channels.

Selecting the frequencies to be stored in the channel bank “U”

TUNE

Via the “TUNE” menu, you can select the frequencies to be stored in the chan- nel bank “U” (user bank).

When you have selected one of the channel banks “1” to “8” and then select the “TUNE” menu, the transmitter or receiver automatically switches to channel 01 of the channel bank “U”. In this case, “U.01” briefly appears on the display.

 

Use the / buttons to select the desired transmission or receiving fre-

 

quency. Transmission and receiving frequencies are tunable in 25-kHz

 

steps within a switching bandwidth of 36 MHz max. For intermodulation-

 

free frequencies, please refer to the enclosed frequency table.

 

Scanning the channel banks for free channels (receivers only)

SCAN

Before putting one or several transmission links into operation, you should

 

scan the selected channel bank for free channels In order to ensure intermo-

 

dulation-free operation of your system.

31

Page 31
Image 31
Sennheiser W100 manual Adjustment tips for the operating menu, Switching between channel banks