Sharp CD-CH1500 To check the setting time, Power stand-by mode automatically, Sired function

Advanced Features

– Timer and Sleep Operation –

Timer and Sleep Operation (continued)

6 Turn the jog dial to specify the minute and within 10 seconds,		11 Press the POWER button to enter the timer stand-by mode.
	press the ENTER button.

7 Turn the jog dial to specify the hour to stop and within 10 sec-	To cancel the timer playback or timer recording:
onds, press the ENTER button.
	1.	Press the POWER button to turn the power on.
	2.	Press the MENU button.
	3.	Turn the jog dial to select “TIMER OFF” and then press the ENTER button.

				To check the setting time:
			1.		Press the POWER button to turn the power on.
8 Turn the jog dial to specify the minute and within 10 seconds,			2.		Press the MENU button.
			3.		Turn the jog dial to select “TIMER PLAY” or “TIMER REC” and then press
	press the ENTER button.				the ENTER button.
			4.		Press the POWER button to enter the timer stand-by mode.
				12 When the preset time is reached, playback or recording will start.
				The volume will increase gradually until it reaches the volume you were listen-
				ing to before your system enters the timer stand-by mode.
				13 When the timer end time is reached, the system will enter the
	Start time	End time		power stand-by mode automatically.
				If you press any button during timer operation, the timer mode is canceled and
				playback or recording will last even when the end time is reached.

9 Adjust the volume using the VOLUME buttons.

Do not turn the volume up too high.	To reset or change the timer setting:
	Perform “Timer playback or Timer recording” from the beginning.
10 Press the CD, TUNER (BAND) or TAPE button to select the de-
	Notes:
sired function.
To select the timer playback source : CD, TUNER (BAND) or TAPE.	● Once the time is set, the setting will be retained until a new time is entered.
	● When performing timer playback or recording using another unit connected to the
To select the timer recording source : TUNER (BAND).
	AUX IN jacks, select “AUX” in step 10. At this time, only this stereo system will enter
	the power stand-by mode automatically. (Another unit will not be turned off.)

26