Sharp DM-4500, DM-4551, DM-3551, DM-3501 Using the key operator programs, KEY Operator Programs

KEY OPERATOR PROGRAMS

Using the key operator programs

Use the following procedure to use the key operator programs.

NOTE

When using the key operator programs for the first time, register a key operator code number (password required for using the key operator programs). (See steps 3 and 5 below or see steps 3 and 5 on page 7-5.)

❇When using the operation panel with touch panel, see page xxxx.

When using the operation panel on the main unit:

1Press the [MENU] key.

Press the [MENU] key repeatedly until the

message "KEY

OPERATOR PROGRAMS" appears.

KEY OPERATOR PROGRAMS

Use the same procedure as step 3 to enter the

4password from the fourth digit to the first digit and then press the [OK] key.

KEY OPERATOR CODE

O

Use the same procedure as above (fifth digit) to enter the fourth digit to the first digit.

Press the [] or [] key to select the desired

5program and press the [OK] key.

2Press the [OK] key.

KEY OPERATOR CODE		If the [OK] key is pressed,
		the message shown to the
	O
		left will appear.
3
	Enter the fifth digit of the password and press
	the [OK] key.

KEY OPERATOR CODE	For the factory default
	setting of the key operator
O
	code number (password),
	see page xxxx.

If you press the [OK] key to register the fifth digit after entering it using the or key on the operation panel, "0" will appear at the fourth digit. If you press the [BACK/C] key, you can correct the entered number.

	<Example>
	For registration of a key
	operator	code number,
	select "KEY OPERATOR
	CODE CHANGE"			and	6
	press the [OK] key.
6	Press the [ ] or [ ] key to select the desired
	item.
	For settings		of	each
	program, see the details of
	classification		of setting
	items	(hierarchical
	structure)			and
	supplementary explanation

of key operation on and after page xxxx.

7To exit the program, press the [MENU] key.

6-3