INFORMATION

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the operation manual, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and the receiver.

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

U.S.A. ONLY

Declaration of Conformity

SHARP PROJECTOR, MODEL DT-200

This device complies with Part 15 of the FCC rules. Operation is subject to the following conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Responsible Party:

 

SHARP ELECTRONICS CORPORATION

 

Sharp Plaza, Mahwah, New Jersey 07430

 

TEL: 1-800-BE-SHARP (1-800-237-4277)

U.S.A. ONLY

WARNING:

The cooling fan in this projector continues to run for about 90 seconds after the projector is turned off. During normal operation, when turning the power off always use the OFF button on the projector or on the remote control. Ensure the cooling fan has stopped before disconnecting the power cord.

DURING NORMAL OPERATION, NEVER TURN THE PROJECTOR OFF BY DISCONNECTING THE POWER CORD. FAILURE TO OBSERVE THIS WILL RESULT IN PREMATURE LAMP FAILURE.

Caution Concerning the Lamp Replacement

There is potential glass particles hazard if the lamp ruptures.

ENGLISH

LAMP REPLACEMENT

PRECAUTIONS A OBSERVER LORS

CAUTION

DU REMPLACEMENT DE LA LAMPE.

BEFORE REMOVING THE SCREW, DISCONNECT POWER CORD.

DEBRANCHER LE CORDON D’ALIMENTATION AVANT DE RETIRER LES VIS.

HOT SURFACE INSIDE. ALLOW 1 HOUR TO COOL BEFORE

L’INTERIEUR DU BOITIER ETANT EXTREMEMENT CHAUD, ATTENDRE

REPLACING THE LAMP. REPLACE WITH SAME SHARP LAMP

1 HEURE AVANT DE PROCEDER AU REMPLACEMENT DE LA LAMPE.

UNIT TYPE BQC-XVZ90+++1 ONLY. UV RADIATION : CAN CAUSE

NE REMPLACER QUE PAR UNE LAMPE SHARP DE TYPE BQC-XVZ90+++1.

EYE DAMAGE. TURN OFF LAMP BEFORE SERVICING.

RAYONS ULTRAVIOLETS : PEUVENT ENDOMMAGER LES YEUX.

MEDIUM PRESSURE LAMP : RISK OF EXPLOSION.

ETEINDRE LA LAMPE AVANT DE PROCEDER A L’ENTRETIEN.

POTENTIAL HAZARD OF GLASS PARTICLES IF LAMP HAS

LAMPE A MOYENNE PRESSION : RISQUE D’EXPLOSION.

RUPTURED. HANDLE WITH CARE. SEE OPERATION MANUAL.

DANGER POTENTIEL DE PARTICULES DE VERRE EN CAS D’ECLATEMENT DE LA LAMPE.

 

A MANIPULER AVEC PRECAUTION, SE REPORTER AU MODE D’EMPLOI.

 

 

WARNING:

Some IC chips in this product include confidential and/or trade secret property belonging to Texas Instruments. Therefore you may not copy, modify, adapt, translate, distribute, reverse engineer, reverse assemble or discompile the contents thereof.

E-2