IMPORTANT SAFEGUARDS
Caution Concerning the Lamp Unit
There is a potential hazard of glass particles if the lamp ruptures. In case of lamp rupture, contact your nearest Sharp Authorized Service Center or Dealer for a replacement.
See “Replacing the Lamp” on page 45.
CAUTION
PRECAUCIÓN
PRÉCAUTION
This caution is found at the bottom of the projector. See “Caution Concerning the Lamp Replacement” on page 2 for its location.
LAMP REPLACEMENT | PRECAUTIONS A OBSERVER LORS |
CAUTION | DU REMPLACEMENT DE LA LAMPE. |
BEFORE REMOVING THE SCREW, DISCONNECT POWER CORD. | DEBRANCHER LE CORDON D’ALIMENTATION AVANT DE RETIRER LES VIS. |
HOT SURFACE INSIDE. ALLOW 1 HOUR TO COOL BEFORE | L’INTERIEUR DU BOITIER ETANT EXTREMEMENT CHAUD, ATTENDRE |
REPLACING THE LAMP. REPLACE WITH SAME SHARP LAMP | 1 HEURE AVANT DE PROCEDER AU REMPLACEMENT DE LA LAMPE. |
UNIT TYPE | NE REMPLACER QUE PAR UNE LAMPE SHARP DE TYPE |
EYE DAMAGE. TURN OFF LAMP BEFORE SERVICING. | RAYONS ULTRAVIOLETS : PEUVENT ENDOMMAGER LES YEUX. |
MEDIUM PRESSURE LAMP : RISK OF EXPLOSION. | ETEINDRE LA LAMPE AVANT DE PROCEDER A L’ENTRETIEN. |
POTENTIAL HAZARD OF GLASS PARTICLES IF LAMP HAS | LAMPE A MOYENNE PRESSION : RISQUE D’EXPLOSION. |
RUPTURED. HANDLE WITH CARE. SEE OPERATION MANUAL. | DANGER POTENTIEL DE PARTICULES DE VERRE EN CAS D’ECLATEMENT DE LA LAMPE. |
| A MANIPULER AVEC PRECAUTION, SE REPORTER AU MODE D’EMPLOI. |
|
|
| Information | Important | |
|
|
|
|
|
|
|
|
|
|
|
|
95˚F
(+35˚C)
41˚F | |
(+5˚C) |
|
Cautions Concerning the Setup of the Projector
For minimal servicing and to maintain high image quality, SHARP recommends that this projector be installed in an area free from humidity, dust and cigarette smoke. When the projector is subjected to these environments, the lens and part of filter must be cleaned more often than usual. As long as the projector is properly maintained in this manner, use in these environments will not reduce the overall operation life. Please note that all internal cleaning must be performed by a Sharp Authorized Service Center or Dealer.
•Do not expose the projector to extreme heat or cold. Operating temperature: 41°F to 95°F (+5°C to 35°C) Storage temperature:
Notes on Operation
•The exhaust ventilative hole, the lamp cage cover and adjacent areas may get extremely hot during projector operation. To prevent injury, do not touch these areas until they have sufficiently cooled down.
•Allow at least 1 foot (30 cm) of space between the exhaust ventilative hole and the nearest wall or obstruction.
•If the cooling fan becomes obstructed, a protection device will automatically turn off the projector lamp. This does not indicate a malfunction. Remove the projector power cord from the wall outlet and wait at least 10 minutes. Then turn on the power by plugging the power cord back in. This will return the projector to the normal operating condition.
WARNING: High brightness light source. Do not stare into the beam of light, or view directly. Be especially careful that children do not stare directly into the beam of light.