Using the Kensington Lock
Rear View | This projector has a Kensington Security Standard |
connector for use with a Kensington MicroSaver Security | |
| System. Refer to the information that came with the |
| system for instructions on how to use it to secure the |
Kensington Security | projector. |
Standard connector |
|
Troubleshooting
&Troubleshooting
Maintenance
Problem | Check |
No picture appears. | • Projector power cord is not plugged into the wall outlet. |
| • Selected input is wrong. (See page 24.) |
| • Cables incorrectly connected to back panel of the projector. (See pages |
| • “Contrast” and “Bright” adjustments are set to minimum position. |
|
|
Color is faded or poor. | • Picture adjustments are not correct. |
|
|
Picture is blurred. | • Adjust the focus. (See page 16.) |
| • Projection distance is too long or too short to allow for proper focus. (See pages 21 and 22.) |
|
|
No OSD appears. | • OSD Display is set to “OFF”, preventing to display some or all |
| page 36.) |
|
|
An unusual sound is occasion- | • If the picture is normal, the sound is due to cabinet shrinkage caused by temperature |
ally heard from the cabinet. | changes. This will not affect operation or performance of the projector. |
|
|
Maintenance indicator | • Refer to “Lamp/Maintenance Indicators” on page 43. |
illuminates. |
|
|
|
Picture noise appears. | • Adjust the “Phase” setting. (See page 33.) |
|
|
Image is green on INPUT 2 | • Change the input signal type. (See page 36.) |
Component. |
|
Image is pink (no green) on |
|
INPUT 2 RGB. |
|
|
|
Service Information (For the U.S.)
For the location of the nearest Sharp Authorized Service Center, or to obtain product literature, accessories, supplies or customer assistance, please call