Troubleshooting

Problem

Suggested Solution

Cassette cannot be loaded.

Make sure there is no other cassette inside.

 

Make sure the cassette is correctly positioned and then reinsert.

 

 

Picture does not change even

Make sure the Product is not in the timer setting or clock setting

though CH ' / " are pressed.

mode.

 

 

Selected programme position does

The channel may have been set to be skipped.

not appear.

Cancel the skip setting for that channel.

 

 

No colour appears during video

When a tape is recorded in the LP mode in the MESECAM

search and the like.

system, the picture is discoloured during video search, still and

 

similar modes. However, this does not indicate a malfunction.

 

 

Picture is skewed.

If a tape is recorded in the LP mode (regardless of whether it is a

 

MESECAM or PAL tape), the picture is skewed during video

 

search. However, this does not indicate a malfunction.

NICAM sound cannot be output.

Is NICAM set to OFF on the OSD mode?

 

 

DVD

Problem

Suggested Solution

 

 

The Product is switched on but does

Have you loaded a disc?

not operate.

Is the disc unplayable? (See pages 3 – 5.)

 

Is there dew in the Product? (See page 2.)

 

 

The playback image does not

Are the video and audio cables connected correctly? (See pages

appear.

14 – 17.)

No sound is produced.

Is the disc scratched? (See page 5.)

Is the disc dirty? (See page 5.)

Is the disc loaded upside down?

Is the input selector on the TV set to “VIDEO” or “AV”?

Is the audio equipment switched on and are all the components connected properly? (Refer to the operation manuals for your audio equipment.)

The sound is not Dolby Digital (5ch Is the disc you are playing recorded in Dolby Digital (5ch or

or 5.1ch).

5.1ch)?

Have you set the “ DIGITAL” in “AUDIO SETUP” to

 

“BITSTREAM”? (See page 45.)

The image and sound are garbled.

Is the disc scratched? (See page 5.)

Are vibrations from the speakers affecting the Product?

The sound is not stable during Set the “COMPRESSION” in “AUDIO SETUP” to “OFF” (See page

playback.

45.)

This Product is equipped with a microprocessor. Its performance could be adversely affected by external electrical noise or interference. If this should happen, unplug the Product and plug it in again after a few minutes.

GB 100

Page 102
Image 102
Sharp DV-NC70 and DV-NC70X, DV-NC70W operation manual Troubleshooting