Sharp DV-NC70 and DV-NC70X, DV-NC70W TV Programme Recording, Cassette Erase Protection

Insert the cassette, making sure the erasure protection hole is covered.

Select the channel position you wish to record with CH ' / ".

Recording a TV Programme

Preparation

TV Programme Recording

Cassette Erase Protection

A , cassette has a removable tab to prevent accidental

PAL SECAM

erasure of recorded material. Removing the tab prevents recording. To record on a video cassette with the tab removed, place adhesive tape over the tab opening.

ERASURE

PROTECTION TAB

•Press OPERATE. Then move the VCR/DVD CHANGE Switch to VCR.

•Ensure the Video channel is selected on the TV.

1

OPERATE ON/OFFTIMER

ON

DISPLAY SCREEN

DV- NC70W

DV- NC70

DV- NC70X

EJECT

VCR/DVD VCR MENU SELECTOR DVD SETUP

G-CODE

PROG

2

3 Select the SP (Standard Play), EP (Extended Play) or LP (Long Play) recording speed with TAPE SPEED on the Remote (“SP”, “EP” or “LP” will light up on the VCR Front Panel display.) SP (Standard Play) gives the best picture quality, EP (Extended Play) gives the triple recording time and LP (Long Play) gives the double recording time.

•If the COLOUR mode is set to “AUTO” or “MESECAM”, when a SECAM signal is received and the EP mode is selected, the Product will automatically change the EP mode to LP mode.

4 Press ÆREC. (If the erasure protection hole is uncovered, the cassette will be ejected.) To pause during recording, press âPAUSE/STILL. To resume recording, press âPAUSE/STILL again.

5 To stop recording, press ËSTOP.

•The pause mode disengages automatically after about 5 minutes, and the Product enters stop mode.

•To record audio and video from an external source through the AUDIO/VIDEO terminal on the rear of the Product, press INPUT SELECT on the Remote to select the AV channel position situated between the last channel and first channel. (When the AV position is selected, “L1” or “L2” is displayed where a channel position number is usually displayed.)

•If the TV signals are weak and the picture changes to monochrome, set the strict colour mode on the MODE selection screen. (See ”Mode Selection” on page 23.) Normally, the colour mode should be set to “AUTO”.

FUNCTION	PROG/	ANGLE	OPEN/
CONTROL	REPEAT		CLOSE
TITLE			DVD MENU
CLEAR			SET
RETURN			ENTER
			ZERO BACK
			SKIP SEARCH
AM/PM	INPUT SELECT VCR DVD
/
REV			FWD
	PLAY
REC			PAUSE/STILL
	STOP
TAPE	DPSS		SLOW
SPEED	SKIP
CH		AUDIO
	OUTPUT
	VCR	DVD

VCR/DVD COMBINATION

To Watch Another TV Programme While Recording

After steps 1 to 4 have been completed, select the programme you wish to view using the TV tuner. At the end of the tape, your Product will automatically stop recording, rewind the tape, eject it and then turn off the power. If a DVD is being played back, the power will not turn off.

GB 62