Sharp DV-NC70W operation manual Setting the Programme Number In Step, 67 GB, PR Preset Channel

Programming the Timer with G-CODE®System

7 Press VCR MENU to return to the normal screen.

8 To set the product for automatic timer recording, press TIMER ON/OFF and ensure the “ ” lights on the VCR Front Panel display.

VCR

L R

SEPVP D

OPERATE ON/OFFTIMER

ON

DISPLAY SCREEN

DV- NC70W	G-CODE
DV- NC70	PROG
DV- NC70X

EJECT

VCR/DVD VCR MENU

SELECTOR DVD SETUP

•Please be sure to check that the start and end times of two different programmes do not overlap, as the remote control has been designed to accept the basic individual G-CODEnumber only. If the recording periods of two programmes overlap, the beginning of the second programme will not be recorded.

•To cancel the programmed G-CODEsetting, select the TIMER setting

mode on the menu screen. Then select the programme number you wish to cancel with ' / " and press CLEAR. (See “Cancelling Timer Programmes” on page 72.)

FUNCTION	PROG/	ANGLE	OPEN/
CONTROL	REPEAT		CLOSE
TITLE			DVD MENU
CLEAR			SET
RETURN			ENTER
			ZERO BACK
			SKIP SEARCH

Setting the Programme Number In Step 4

When using the G-CODEsystem for the first time the Programme number (PR) on the screen shows two dashes and is highlighted white. Set it to be the same as the PR number to which your broad- casting channel is set into.

For instance if you can view CH 47 on programme (PR) 47, set the On screen PR number to 47.

•You need to set this only once.

•If the channels are retuned you need to set the PR numbers again.

AM/PM	INPUT SELECT VCR DVD
/
REV		FWD
	PLAY
REC		PAUSE/STILL
	STOP
TAPE	DPSS	SLOW
SPEED	SKIP
CH	AUDIO
	OUTPUT
	VCR	DVD

PR: Preset Channel

1/2

DATE PR START STOP VCR/DVD COMBINATION

15/12 --12:00PM12:30PM SP --/-- -- -:-- -:-- --

--/-- -- -:-- -:-- --

--/-- -- -:-- -:-- --

PR :PRESET CH

:SELECT :CHANGE

SET:ENTER MENU:EXIT

67 GB