Sharp LC-32LE155X Initial auto installation, Checking Signal information, Auto installation

Initial auto installation

When the TV powers on for the first time after purchase, the initial auto installation wizard appears. Follow the menu and make the necessary settings one after another.

1Press POWER on the TV.

• The initial auto installation wizard appears.

2Press a/b to select your country channels listed on the screen, and then press ENTER.

Press a/b to select “HOME” or “STORE”, and then press ENTER.

HOME:

•“STANDARD” will be the default value for the “AV mode” setting.

STORE:

•“DYNAMIC (FIXED)” will be the default value for the “AV mode” setting. If the “AV mode” is changed, the TV will automatically switch back to “DYNAMIC (FIXED)” when there is no further change to TV setting for 30 minutes.

•The confi rmation screen appears only when selecting

“STORE”.

Press a/b to select “Yes” or “No”.

•To change the STORE mode to HOME mode, please refer to page 13 to reset the unit.

Press a/b to select “DTV”, “ATV” or “DTV + ATV”, and then press ENTER.

•Auto installation will be executed.

•You do not need to do anything during the auto search.

Checking Signal information

If you install a DVB-T antenna for the fi rst time or relocate it, you should adjust the alignment of the antenna to receive a good reception while checking the antenna setup screen.

ATV/DTV

1Press MENU and the MENU screen displays.

2Press c/d to select “” (Programme setup).

3Press a/b to select “Digital setting”, and then press

ENTER.

4Press a/b to select “Signal Information”, and then press ENTER.

• The “Signal Information” screen will appear.

Auto installation

You can run auto installation again, even after setting up the preset channels.

1Press MENU and the MENU screen displays.

2Press c/d to select “” (Programme setup).

3Press a/b to select “Auto installation”, and then press ENTER.

If you have already set the password, enter it here.

• See page 12 for setting a password.

4Press a/b to select your country channels listed on the screen, and then press ENTER.

Press a/b to select “DTV”, “ATV” or “DTV + ATV”, and then press ENTER.

You do not need to do anything during the auto search. Press MENU to exit.

Programme setup

Digital setting

You can reconfi gure DTV services settings automatically or manually.

1Press MENU and the MENU screen displays.

2Press c/d to select “” (Programme setup).

3Press a/b to select “Digital setting”, and then press ENTER. If you have already set the password, enter it here.

• See page 12 for setting a password.

4Press a/b to select the desired menu item, and then press ENTER.

H Auto search

Use this menu to add new services automatically after auto installation has been completed.

H Manual search

Add new services within a specifi ed frequency band.

• Press c/d to select the frequency and then press ENTER.

8