PC compatibility chart, PC Control of the TV

PC compatibility chart

Resolution		Horizontal	Vertical	VESA Standard	Analogue	Digital (HDMI)
Resolution		Frequency	Frequency	VESA Standard	(D-Sub)	Digital (HDMI)
		Frequency	Frequency		(D-Sub)

VGA	640 g 480	31.5 kHz	60 Hz	✔	✔	✔
SVGA	800 g 600	37.9 kHz	60 Hz	✔	✔	✔
XGA	1024 g 768	48.4 kHz	60 Hz	✔	✔	✔
WXGA	1360 g 768	47.7 kHz	60 Hz	✔	✔	✔
✴ 1080P	✴ 1920 g 1080	67.5 kHz	60 Hz		✔	✔

✴: only for LC-39LE155X

DDC is a registered trademark of Video Electronics Standards Association. Power Management is a registered trademark of Sun Microsystems, Inc.

VGA, SVGA, XGA and WXGA are registered trademarks of International Business Machines Corporation.

PC Control of the TV

•When a programme is set, the TV can be controlled from the PC using the RS-232C terminal.

The input signal (PC/video) can be selected, the volume can be adjusted and various other adjustments and settings can be made, enabling automatic programmed playing.

•Attach an RS-232C cable cross-type (commercially available) to the Din/D-sub RS-232C for the connections.

NOTE

•This operation system should be used by a person who is accustomed to using PCs.

Communication conditions

Set the RS-232C communications settings on the PC to match the communications conditions of the TV. The communications settings of the TV are as follows:

Baud rate:	9,600 bps

Data length:	8 bits

Parity bit:	None

Stop bit:	1 bit

Flow control:	None

Communication procedure

Send the control commands from the PC via the RS-232C connector.

The TV operates according to the received command and sends a response message to the PC.

Do not send multiple commands at the same time. Wait until the PC receives the OK response before sending the next command.

Command format

Eight ASCII codes e CR

C1 C2 C3 C4 P1 P2 P3 P4

Command 4-digits Parameter 4-digits Return code

Command 4-digits: Command. The text of four characters.

Parameter 4-digits: Parameter 0 – 9, space, ?

Parameter

Input the parameter values, aligning left, and ﬁ ll with space(s) for the remainder. (Be sure that four values are input for the parameter.)

When the input parameter is not correct, “ERR” returns. (Refer to “Response code format”.)

0					0	0	0	9		a	3	0

Response code format

Normal response

Return code (0DH)

Problem response (communication error or incorrect command)