47
Appendix

Troubleshooting

Cautions regarding use in high and low temperature environments

• When the unit is used in a low temperature space (e.g. room, office), the picture may leave trails or appear
slightly delayed. This is not a malfunction, and the unit will recover when the temperature returns to normal.
• Do not leave the unit in a hot or cold location. Also, do not leave the unit in a location exposed to direct sunlight
or near a heater, as this may cause the cabinet to deform and the LCD panel to malfunction.
Storage temperature: –20°C to +60°C.
• No power.
• Unit cannot be operated.
• Remote control unit does not
operate.
• Picture is cut off.
• Strange colour, light colour, or
dark, or colour misalignment.
• Power is suddenly turned off.
• No picture.
• No sound.
Problem Possible Solution
• Check if you pressed POWER on the remote control unit. (See page 16.)
If the indicator on the TV lights up red, press POWER.
• Is the AC cord disconnected? (See page 6.)
• Has the power been turned on? (See page 16.)
• External influences such as lightning, static electricity, etc., may cause improper
operation. In this case, operate the unit after first turning the power off the TV or
unplugging the AC cord and re-plugging it in after 1 or 2 minutes.
• Are batteries inserted with polarity (e, f) aligned? (See page 5.)
• Are batteries worn out? (Replace with new batteries.)
• Are you using it under strong or fluorescent lighting?
• Is a fluorescent light illuminated to remote control sensor?
• Is the image position correct? (See page 36.)
• Are screen mode adjustments such as picture size made correctly? (See pages
37, 39 and 40.)
• Adjust the picture tone. (See pages 27 to 29 and 41.)
• Is the room too bright? The picture may look dark in a room that is too bright.
• Check the colour system setting. (See pages 23 and 42.)
• Check the input signal setting. (See pages 34 and 43.)
• Check the HDMI Setup setting. (See page 41.)
• The unit’s internal temperature has increased.
Remove any objects blocking vent or clean.
• Check the power control setting. (See page 31.)
• Is sleep timer set? (See page 18.)
• Is connection to other equipment correct? (See pages 11 and 12)
• Has input signal setup been done correctly after connection? (See pages 34
and 43.)
• Is the correct input selected? (See page 43.)
• Is picture adjustment correct? (See pages 27 to 29.)
• Is the antenna connected properly? (See page 10.)
• Is “On” selected in “Audio Only”? (See page 41.)
• Is the volume too low? (See page 18.)
• Make sure that headphones are not connected. (See page 13.)
LC-G7X_E-k 06.12.21, 9:06 AM47