Initial auto installation
Initial auto installation
When the TV is powered on for the first time after purchase, the initial auto installation wizard appears. Follow the menus and make the necessary settings one after another.
Confirm the following before turning on the power
EIs the antenna cable connected? E Is the AC cord plugged in?
Important information:
Satellite services are only available for the 835 model series.
1Press <on the TV.
• The initial auto installation wizard appears.
2Setting the OSD language.
Press a/b/c/dto select the desired language, and then press ;.
3Selecting the location of the TV.
|
|
|
|
|
| HOME |
| STORE |
|
|
|
|
|
|
Press c/dto select where you will use this TV, and then press ;.
•The confirmation screen pops up only when selecting “STORE”. Press c/dto select “Yes” or “No”.
•HOME: “STANDARD” will be the default value for the “AV mode” setting.
•STORE: “DYNAMIC (Fixed)” will be the default value for the “AV mode” setting. If the “AV mode” is changed, the TV will automatically switch back to “DYNAMIC (Fixed)” when there is no operation using the TV or remote control unit for 30 minutes.
•STORE: A demonstration image will be displayed after initial auto installation is completed. If you have chosen “STORE” by mistake, go to “Menu” > “Setup” > “View setting” > “Reset” > select “HOME” again.
4Setting the country.
Press a/b/c/dto select your country or area, and then press ;.
•This setting screen only appears during the initial auto installation.
NOTE
•Some functions may not display or be selectable depending on the country setting or cable provider selection.
5Setting the PIN.
1Press c/dto select “Yes”, and then press
;.
•When “No” is selected, the PIN code setting is skipped.
2Enter a
3Enter the same
4Press ;.
NOTE
•When “France” is selected in the country setting, the PIN code setting cannot be skipped.
•“0000” cannot be set as the PIN code.
•When the PIN code setting is skipped, the default PIN code (“1234”) will automatically be set.
•To change the PIN setting, refer to Individual setting – PIN (Page 40). To reset the PIN setting (PIN input will no longer be needed), refer to Reset the PIN (Page 71).
6Starting channel search.
Digital search
Analogue search
Satellite search
Press a/bto select “Digital search”, “Analogue search” or “Satellite search”, and then press ;.
•(835 series only) After performing “Digital search” or “Analogue search”, the screen switches to the “Satellite search” setting. You should then execute “Yes” if you want to search for satellite channels.
•To watch both digital broadcasts and analogue broadcasts, you should perform “Digital search” or “Analogue search” from “Auto installation” under the “Setup” menu (Page 37).
•When you select “Satellite search”, only satellite broadcasts will be searched.
•If you want to search for more broadcasts, execute “Additional search” from the “Programme setup” menu (Pages 37_39).
NOTE
•If you turn off the power on the TV while performing a channel search, the initial auto installation wizard will not appear. The auto installation function allows you to execute the installation again from “Menu” > “Setup” > “View setting” (Page 37).
•The initial auto installation wizard will abort if you leave the TV unattended for 30 minutes before searching for channels.
•When “Italy” or “France” is selected in the country setting, the default age restriction value is set to 18.
14
