Instructions for installing a VESA compliant arm

An arm based on the VESA standard can be attached to the monitor. The arm must be purchased separately.

When choosing the arm to be installed please take note of the following points.

The arm should be compatible with the VESA standard, and there must be a gap of 75mm x 75mm between the screw holes on the section to be attached.

The arm must not fall off or break off after being attached to the monitor.

CAUTION!

Be careful not to cut or jam your fingers.

Note:

Do not bend the signal cable or the AC adapter cable nor place weight on them. Doing so could lead to damage.

1.Turn off the power switch and remove the power plug from the power source.

2.Remove the rear cover, stand cover and adapter cover.

To remove them follow steps 1, 2, and 3 of Connecting the monitor to a power source on page 12.

3.Remove the AC adapter from the stand.

4.Being careful not to damage the monitor, spread out a soft cloth and lay the monitor on it display-side down.

5.Remove the four screws and then remove the stand from the monitor.

Information

The stand is specially made for use with this monitor. Once having removed the stand, never attempt to attach it to another device.

Once having removed the screws, store them together with the stand and if the stand is ever re- attached be sure to use the original screws. Using different screws could lead to malfunction.

6.Attach the rear cover.

To attach it follow step 8 of Connecting the monitor to a power source on page 12.

7.Attach the arm to the monitor with four screws.

Information

4 ~ 6 mm

The screws used to

 

 

 

 

 

 

 

 

 

 

 

 

 

 

attach the arm should be

 

 

 

 

 

 

 

M4 screws with a length

 

 

 

 

 

 

 

 

 

 

 

 

 

 

of 4 mm ~ 6 mm

 

 

 

 

 

 

 

 

 

 

 

 

 

 

protruding from the

 

 

 

 

 

 

 

 

 

 

 

 

 

 

surface to be attached.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Using different screws

 

 

 

 

 

 

 

 

 

 

 

 

 

 

could lead to malfunction

 

 

 

 

 

 

 

or may lead to the

 

 

 

 

 

 

 

monitor falling off,

 

 

 

 

 

 

 

internal damaged,

 

 

 

 

 

 

 

personal injury.

 

 

 

 

 

 

 

Screw used to attach arm

Arm

Part of monitor to which arm is attached

30

Page 30
Image 30
Sharp LL-T1610W operation manual Instructions for installing a Vesa compliant arm, Attach the rear cover