Sharp R-2120J Tools Recommended for Installation, Installation Hardware, Name Quantity Part Code

U N P A C K I N G A N D I N S T A L L A T I O N I N S T R U C T I O N S

5 TOOLS RECOMMENDED FOR INSTALLATION

• Phillips Screwdriver	• Saw to cut exhaust opening
• Electric Drill	(if needed)
• 1/2”, 5/8” and 3/32” Drill Bits	• Protective Drop Cloth for product and
	range - you may also use carton for
• 1-1/2” Wood Bit or Metal Hole Cutter
	protection
(if metal cabinet is used)

•Scissors

•Pencil

•Measure

•Tape

6 INSTALLATION HARDWARE

The INSTALLATION HARDWARE items 1 - 7 are in a small bag. Items 8 - " are packed separately. All items are in a small carton packed below the oven.

	ITEM		NAME		QUANTITY	PART CODE
	1	Wood Screw 5 X 30 mm			6*	XTSSD50P35000
	2	Toggle Bolt with nuts #10 - 24 X 50 mm			4**	LX-BZ0195WRE0
	3	Top Cabinet Screw 5 X 60 mm			2	XBRSD50P60000
	4	Power Cord Hanger			1	LX-MZB001MRE0
	5	Tapping Screw 4 x 12 mm			8	XOTSE40P12000
	6	Flat Washer 30 mm diameter			2	XWHSD50-16300
	7	Grommet			1	LBSHC0040MRE0
	8	Rear Cushion			1	PCUSUB059MRP0
9		Exhaust Damper Assembly			1	FFTA-B005MRK0
	! Scale Plate				2	LANG-B004MRP0
	" Grease Filter				2	PFIL-B008MRE0
	# Bottom Sash				1	HDEC-B001MRF0
* Must use two - may use remaining four.				**May not use all depending on stud location.

Figure 4

Parts shown not to common scale.

8