Installation
1. Insert the receptacle into terminal insulator.
Terminal | Flat type | |
screw driver | ||
insulator | ||
|
2.Close covers of the terminal insulator, as shown illustlated below.
COVERS
RECEPTACLE
CONTROL PANEL ASSEMBLY AND CONTROL UNIT REMOVAL
CONTROL PANEL ASSEMBLY REMOVAL
The complete control panel should be removed for re- placement of components. To remove the control panel, proceed as follows:
1.Disconnect the oven from power supply.
2.Wait for 60 seconds to discharge the high voltage capacitor.
3.Remove the air intake filter assembly from the base plate.
4.Remove two (2) screws holding the control panel to the base plate.
5.Pull down the control panel and remove it forward.
6.Disconnect connectors and wire leads from the control unit.
7.Now the control panel assembly is free.
CAUTION FOR TOUCH CONTROL PANEL REMOVAL
1)Hold the lower end (Position A, Fig. 1) of the touch control panel assembly firmly while sliding it down and toward you.
2)If the Touch Control Panel is hard to remove;
(1)Insert a flat head screw driver into space B . (Fig. 1)
(2)Rotate the screwdriver clockwise while holding posi- tion C of the Touch Control Panel. (Fig. 2)
TO AVOID DAMAGE TO TOUCH CONTROL PANEL, COVER THE TIP OF SCREWDRIVER WITH TAPE.
Fig. 1 | Fig. 2 |
B
B
Replacement of individual component is as follows:
CONTROL UNIT AND CONTROL PANEL FRAME (WITH KEY)
8.Remove three (3) screws holding the control panel mounting angle to the panel frame.
9.Lift up the control panel mounting angle from the panel frame.
10.Disconnect connector (G) from the control unit by pushing the hooks of cable holder inwardly.
11.Remove four (4) screws holding the control unit to the panel frame assembly.
12.Now, the control unit and control panel frame (with key) are free.
CAUTION:
At installing control panel unit assembly to main body set:
1.Ensure the installation of wiring-related parts without negligence.
2.When inserting key cable to main body set, ensure them free from
3.Do not allow any wire leads to come near the varistor works, because it will explode and the wire leads near by the varistor will be damaged.
HOW TO ATTACH MEMBRANE SWITCH AND GRAPHIC SHEET
A C
TOUCH CONTROL PANEL
SCREW DRIVER
1.Before attaching a new membrane switch and graphic sheet, remove remaining adhesive on the control panel frame surfaces completely with a soft cloth soaked in alcohol.
2.Attach the graphic sheet to the membrane switch, with adjusting their upper edges and right edges. (This assembly part is called key unit in the following.)
NOTE : When attaching the graphic sheet, make sure that air does not come between the membrane switch and the graphic sheet.
3.Then, adjust the upper edge and right edge of the key unit to the lower edge of the display window and the right flange of the control panel frame.
4.Stick the key unit firmly to the control panel frame by rubbing with soft cloth to prevent scratching.
POWER SUPPLY CORD REPLACEMENT
1.CARRY OUT 3D CHECKS
2.Release the cord bushing from the rear cabinet.
3.Disconnect the brown and blue wires of the power
supply cord from the noise filter.
4.Remove the single (1) screw holding the earth wire of power supply cord.
27