CAUTION:
1.DISCHARGE THE TWO HIGH VOLTAGE CAPACI- TORS BEFORE TOUCHING ANY OVEN COMPO- NENTS OR WIRING.
2.DO NOT REPLACE ONLY THE HIGH VOLTAGE RECTIFIER. IF IT IS DEFECTIVE, REPLACE THE
HIGH VOLTAGE RECTIFIER ASSEMBLY.
3.WHEN REPLACING THE HIGH VOLTAGE RECTI- FIER ASSEMBLY AND THE HIGH VOLTAGE CA- PACITOR, THE CATHODE (EARTH) SIDE TERMI- NAL OF THE HIGH VOLTAGE RECTIFIER MUST BE SECURED FIRMLY WITH A EARTHING SCREW.
BLOWER MOTOR REMOVAL
1.CARRY OUT 3D CHECKS.
2.Remove the rear cabinet, too.
3.Disconnect the wire leads from the blower motor and noise filter.
4.Remove the one (1) screw holding the blower motor angle to the oven cavity.
5.Remove the one (1) screw holding the blower motor angle to the chassis support.
6.Remove the one (1) screw holding the air duct to the blower motor.
7.Remove the four (4) screws holding the blower motor angle to the blower motor.
8.Now, the blower motor is free.
STIRRER MOTORS (UPPER AND LOWER) REMOVAL
UPPER
1.CARRY OUT 3D CHECKS.
2.Disconnect the wire leads from the stirrer motor (up- per).
3.Remove the one (1) screw holding the stirrer motor (upper) to the oven cavity.
4.Turn and lift up the stirrer motor (upper).
5.Now, the stirrer motor (upper) is free.
LOWER
1.Disconnect oven from the power supply.
2.Remove the stirrer motor cover by snipping off the
material in four portions.
3.Where the portions have been snipped off bend the portions flat. No sharp edge must be evident after removal of the stirrer motor cover.
4.Disconnect the wire leads from the stirrer motor (lower).
5.Remove the one (1) screw holding the stirrer motor (Lower) to the oven cavity.
6.Now, the stirrer motor (lower) is free.
7.After replacement use one (1) screw (XOTWW40P08000) to fit the stirrer motor cover.
HOW TO RELEASE THE POSITIVE LOCK® CONNECTOR.
Terminal
Procedure |
| |
1. | CARRY OUT 3D CHECKS. | Positive lock® |
2. | Pushing the lever of positive lock® connector, pull down | connector |
| ||
| the connector from the terminal. |
|
3. | Now, the connector is free. |
|
1 Push
CAUTION: WHEN CONNECTING THE POSITIVE LOCK® CONNECTORS TO THE TERMI- NALS, CONNECT THE POSITIVE LOCK® CONNECTOR SO THAT THE LEVER FACES YOU.
Lever
2
Pull down
Figure C-2. How to release the positive lock connector.
OVEN LAMP AND LAMP SOCKET REMOVAL
1.CARRY OUT 3D CHECKS.
2.Remove the oven lamp.
3.Pull the wire leads from the oven lamp socket by pushing the terminal hole of the oven lamp socket with the small flat type screw driver.
4.Lift up the oven lamp socket .
5.Now, the oven lamp socket is free.
Oven lamp socket
Terminal
Wire lead
Terminal hole
Flat type small screw driver
Figure C-3. Oven lamp socket
TERMINAL INSULATOR REPLACEMENT
1.Open covers of the terminal insulator by using small flat type screw driver.
2.Remove the receptacle from the terminal insulator.
3.Now, the terminal insulator is free.
26