Installing the Print Cartridge | Sharp UX-B700 guide

Installing the Print Cartridge

Installing the Print Cartridge

	The initial starter print	When replacing the print
	The initial starter print	cartridge, use a SHARP
	cartridge included with	cartridge, use a SHARP
	cartridge included with	UX-C70Bcartridge. One
	your fax can print about	UX-C70Bcartridge. One
	your fax can print about	cartridge can print about
	300 letter-size pages.	cartridge can print about
	300 letter-size pages.	600 letter-size pages.
		600 letter-size pages.
		The above
		yields are at 4%
		coverage in INK
		SAVE mode.
	Caution!

Do not open the print compartment cover of the machine while it is printing. If opened while printing, printing will stop.

Note: Keep ink cartridges sealed in their packages until you are ready to install them. It is recommended that you do not use a cartridge that has been left unused for a long time after opening, as the print quality may be considerably degraded.

♦Make sure the power cord of the machine is plugged in and paper is loaded before installing or replacing the print cartridge.

1 Open the operation panel.

If PRINTER ERROR or PRINTER ERROR/CHECK PAPER appears...

In the event that the display shows either of the above messages, you must clear the error before installing the print cartridge. The error can usually be cleared by opening and closing the print compartment cover (see Step 2), or if a paper jam has occurred, by removing the paper jam (see page 107).

1. Installation

17

Image 19

Sharp UX-B700 manual Installing the Print Cartridge, Open the operation panel

Contents

UX-B700 About the Telephone Consumer Protection ACT Vertical Introduction Applicable telephone line Paper tray capacity Important safety information Page Table of Contents Printing Lists Maintenance Look at the Operation Panel Stop key Speaker keyHold key COPY/HELP key Unpacking Checklist Installation Open the print compartment cover Points to keep in mind when setting upAttachments Removing the packing tape Close the printer cover Connecting the handset Attaching the paper trays Installation1 Loading Printing Paper Place Connecting the Power Cord Open the operation panel Installing the Print Cartridge Remove only the tape from the the new cartridge Change Cartridge Press OLD if the cartridge you Installed is old Installed is newPress NEW if the cartridge you Press Memory Setting the paper size Press To turn on ink save mode, or Ink save modePress Press Once Times Connecting the Telephone Line Cord Remove the seal covering the TEL. SET jack Extension phone optionalConnect the extension phone line to the TEL. SET jack Entering Your Name and Fax Number Enter your fax number by pressing the number keys max digits Chart below. Up to 24 characters can be entered Press once and 3 times Setting the Date and Time Daylight Saving Time Setting the reception mode Setting the Reception ModeMode Press To select Volume AdjustmentDesired volume level Speaker If you selected Ringer OFF OK ? to When talking through the handset Press To selectHandset Ringer Sending Faxes Size and weightTransmittable Documents Other restrictions Loading the Document Open the operation panel Remove the document Removing a document from the feeder Resolution settings Adjusting the Resolution and ContrastContrast settings Load the documents Press RESOLUTION/ one or more times Changing the default resolution Sending a Fax by Normal Dialing Sending a Fax by Automatic Dialing Sending a Fax by Automatic Dialing Storing fax and phone numbers for automatic dialing Space = Press 1 for Edit or 2 for Clear Editing and clearing auto-dial numbersReturn to to store another number, or press to return to Date and time display To the date and time display Press Memory Make the desired changes to the name Rapid Key Dialing Using a Rapid Key for a voice callLoad the documents If desired, press Speed Dialing Using a Speed Dial number for a voice callMemory . If not, press Repeat Step Press Until the name of the other party appears Searching for an auto-dial numberDisplay if no name was stored, the number will appear Correct, press Memory Sending a fax by Direct Keypad Dialing Press Redial RedialAutomatic redialing Once. Redial appears in the display, followed by Press Function once Times. Display Error Correction Mode Batch Page Numbering Broadcasting sending a fax to multiple destinations Sending a Fax From Memory Press the appropriate Group Key Broadcasting using a Group KeyWhen you are ready to begin transmission, press Memory Load the documents If desired, press RESOLUTION/ to set Press To program a Group Key Storing numbers in Group KeysPress To clear a Group Key Press to return to the date and time display If the memory becomes full Memory transmission Receiving Faxes Using FAX ModeChanging the number of rings Using TEL Mode Using TEL Mode Display shows Receiving and then Answer the extension phone when it ringsAnswering with the fax’s handset Answering on an extension phone connected to the same line Fax Signal Receive Optional Reception SettingsPress once and 7 times Changing the number for remote fax activation Select 100% Reception RatioPress Function once and twice Press To select AUTO, or 2 to Substitute Reception to Memory Making Copies Select any of the following copy settings as neededExample of two Copies each Three originals Press Once Twice When you are ready to begin copying, pressCopy Cut-off If Memory is Full appears Answering Machine Connection Connecting an Answering Machine Set your answering machine to auto answer Using the Answering Machine ConnectionSet the reception mode to A.M Changing the outgoing message How answering machine mode operates Optional A.M. Mode SettingsQuiet Detect Time To turn off the function Enter a number from 01 to 10, or enter Press Function once Quiet Detect Start TimePress once and 6 times On TAD Failure Special Functions Caller ID Requires Subscription to Service Press Memory to store your area code How Caller ID operatesDisplay messages Enter the three digits of your area code Document and then press Memory Fax Voice call Press when you have finished viewing the listViewing the Caller ID list Press Z twice Priority Call To delete calls from the Caller ID listTo store or clear the number Blocking voice calls Distinctive Ring Requires Subscription to Service Set the reception mode to FAX Blocking Reception of Unwanted Faxes Polling Requesting a Fax Transmission Being polled polling standby Requesting transmission Polling security Enter the fax number maximum of 20 digits Storing fax numbers for polling permission Editing and clearing polling permission numbers Press Memory to print the list Printing ListsActivity Report Press Function once and once Caller-ID List Setup ListTelephone Number List Group List Headings in the Transaction Report Transaction Report Transaction Report print condition Press 1 to turn on auto print out, or To turn it off Auto print-out of Activity Report Cleaning the Machine MaintenanceCleaning the scanning glass and rollers Maintenance Rotating the white roller Cleaning the housing Aligning the print cartridge Improving Print Quality Cleaning the print cartridge nozzles Maintenance Wiping the print nozzles and contacts Cleaning the cartridge holder Problem Solution TroubleshootingProblems and Solutions Line error Trouble- shooting Dialing and transmission problems 100 Reception and copying problems General problems Answering machine connection Press Start KEY Messages and Signals 104 Recalling Audible signals Clearing a jammed document Clearing Paper Jams Flip down the green levers on each side of the white roller Clearing jammed printing paper 108 Ordering Parts FCC Regulatory Information A R P Material Safety Data Sheet 2/3 Material Safety Data Sheet 3/3 Sending Faxes Quick Reference Guide Transmisión de documentos Guía de referencia rápida 116 Index 117 118 Limited Warranty Sharp Corporation