Sharp UX-B700 manual Using the Answering Machine Connection, Changing the outgoing message

Using the Answering Machine Connection

Changing the outgoing message

The outgoing message (OGM) of your answering machine should be changed to inform callers who want to send a fax to press their Start key. For example, your message might go as follows:

"Hello. You've reached the ABC company. No one is available to take your call right now. Please leave a message after the beep or press your facsimile Start key to send a fax. Thank you for calling."

♦It is advisable to keep the length of the message under 10 seconds. If it is too long, you may have difficulty receiving faxes sent by automatic dialing.

♦If your outgoing message must be longer than 10 seconds, leave a pause of about four seconds at the beginning of the message. This will give your fax a chance to detect fax tones sent when automatic dialing is used.

Using the Answering Machine Connection

When you go out, activate the answering machine connection as follows:

1 Set the reception mode to A.M.

RESOLUTION/

RECEPTION MODE

TEL FAX

A.M.

Answering	Machine
5.

2 Set your answering machine to auto answer.

♦Your answering machine must be set to answer on a maximum of two rings. If not, you may not be able to receive faxes sent by automatic dialling.

♦If your answering machine has a toll saver function, make sure that it will answer by the fourth ring.

Note: If your answering machine has a remote retrieval function, make sure the code used to activate remote retrieval is different from the code used to activate fax reception with an extension telephone (see page 61). If they are the same, entering the code from an outside telephone to retrieve messages will cause the fax machine to be activated.

67