Turning the Projector On/Off
Connecting the Power Cord
Supplied | Power cord | |
accessory | ||
|
Plug the supplied power cord into the AC socket on the rear of the projector. Then plug into the AC outlet.
Turning the Projector On
Before performing the steps in this section, connect any equipment that you use with the projector. (See pages
Remove the lens cap and press STANDBY/ON on the projector or ON on the remote control.
•The power indicator illuminates green.
•After the lamp indicator illuminates, the projec- tor is ready to start operation.
Note
•The lamp indicator illuminates or blinks, in- dicating the status of the lamp.
Green: The lamp is on.
Blinking green: The lamp is warming up.
Red: The lamp is shut down abnor- mally or the lamp should be replaced.
•When switching on the projector, a slight flicker- ing of the image may be experienced within the first minute after the lamp has been illuminated. This is normal operation as the lamp's control circuitry is stabilizing the lamp output charac- teristics. This does not indicate malfunction.
•If the projector is put into standby mode and immediately turned on again, the lamp may take some time to illuminate.
•When System Lock is set, the keycode in- put box appears. To cancel the keycode set- ting, input the keycode that you have already set. See page 52 for details.
Turning the Power Off (Put-
ting the Projector into Standby Mode)
Press STANDBY/ON on the projector or STANDBY on the remote control, then press that button again while the confirmation mes- sage is displayed, to put the projector into standby mode.
AC socket
To AC outlet
Info
•When ÒAuto RestartÓ is set to ÒOnÓ:
If the power cord is unplugged from the outlet or the breaker switch is turned off when the projector is on, then the projector automatically turns on when the power cord is plugged into the AC outlet or the breaker switch is turned on. (See page 51.)
•English is the factory preset language. If you want to change the
Power indicator | Lamp | |
indicator | ||
| ||
STANDBY/ON button |
| |
ON button |
| |
STANDBY |
| |
button |
|
Info
•Direct Power Off function:
You can unplug the power cord from the AC outlet even if the cooling fan is still running.