Sharp XG-C465X-L Setting a Password, If you forget the password, Changing the Password

Setting up the Projector Network Environment (ÒNetworkÓ menu)

		Pict.	SIG	SCR	PRJ	Network
1	Password				Disable
2	DHCP Client				Off
3	TCP/IP
		MAC Address		XX:XX:XX:XX:XX:XX
4
		Projector		XX-XXXX
		SEL./ADJ.			ENTER
		RETURN			END

1Setting a Password

If you do not want others to change the setting for the ÒNetworkÓ menu, set a password.

Setting a Password

1Select ÒPasswordÓ, then press .

•The screen for entering the password ap- pears.

					Network
Setting the Password
	Old Password	– – – –
	New Password	–	–	–	–
	Reconfirm	– – – –

2Press ' or " to set the first digit in ÒNew PasswordÓ, then press .

3Enter the remaining 3 digits, then press ENTER.

•To return to the previous digit, press \.

4Enter the same password in ÒReconfirmÓ, then press ENTER.

•The status for “Password” changes to “En- able”.

Menu operation Page 43

Changing the Password

1Select ÒPasswordÓ, then press .

•The screen for entering the password ap- pears.

2Enter the password in ÒOld Pass- wordÓ using ', ", and \, then press ENTER.

3Enter the password in ÒNew Pass- wordÓ using ', ", and \, then press ENTER.

4Enter the same password again in ÒReconfirmÓ using ', ", and \, then press ENTER.

Note

•If you do not need the password protection for the “Network” menu settings anymore, press ENTER without entering new password in steps 3 and 4.

•To cancel the password settings, press RETURN.

If you forget the password

If you forget the password, perform the following procedure to delete it, then set a new password.

On the projector, press

Note

•If ENTER is held down for more than 5 seconds, the operation buttons on the projector will be locked. (See page 53.)

•You cannot use the buttons on the remote control to delete the password.

Note

•Once after the password is set, you must enter the password to change the “Network” menu settings.

-54