1 Press KEYSTONE on the projector or on the remote control repeatedly until “GEOMETRIC ADJUSTMENT” is displayed.
2 Press the buttons below to adjust the position, size or focus of the projected image.
•Match screen’s four sides to green test pattern.
•Pressing ', ", \ or on the projector or H&V LENS SHIFT on the remote control allows you to shift the lens.
•Pressing ZOOM +/– on the projector or on the remote control allows you to ad- just the projected image size.
•Pressing FOCUS +/– on the projector or on the remote control allows you to adjust the focus.
3 Press ENTER on the projector or on the remote control.
4 Press ', ", \ or to move the position for the upper left of the image.
•Move the upper left of the yellow frame onto the upper left of the screen.
5 Press ENTER to set the posi- tion.
6 Repeat the same procedure with the positions for the upper right, lower right and lower left of the image.
•At this time, pressing UNDO on the pro- jector or on the remote control returns to the previous screen.
•Before correcting the upper left of the image, pressing UNDO returns to the re- set confirmation screen.
•When the position of the lower left is set, the correction is made and the display disappears.
•If the message “Can not correct.” is dis- played, step 2 may have been performed incorrectly. In this case, go back to step 2 and try the procedure again.
Geometric Adjustment
Upper Left |
| Upper Right | Lower Right | ||
|
|
|
|
|
|
|
|
|
|
|
|
Lower LeftBasic
Operation
-33