Regarding the Lamp

Removing and Installing the Lamp Unit

Warning!

•Do not remove the lamp unit from the pro- jector right after use. The lamp and parts around the lamp will be very hot and may cause burn or injury.

Info

•Make sure the lamp unit is removed using the handle. Make sure the glass surface of the lamp unit or the inside of the projector are not touched.

•To avoid injury to yourself and damage to the lamp, make sure you carefully follow the steps below.

•Do not loosen other screws except for the lamp unit cover and lamp unit.

Optional

Lamp unit

accessory

AN-P610LP

STANDBY button

1Press STANDBY on the projec- tor or on the remote control to put the projector into standby mode.

•Disconnect the power cord and unplug the power cord from the AC socket after the cooling fan stops.

•The cooling fan may continue to run for a while even after the power cord is re- moved.

•Leave the lamp until it has fully cooled down (about 1 hour).

2Remove the lamp unit cover.

•Loosen the user service screw (1) that secures the lamp unit cover. Remove the

lamp unit cover to slide it in the direc- tion of the arrow (2).

Power cord

2

1

User service screw

-72