Image Projection

Switching the Input Mode

Select the appropriate input mode for the connected equipment.

Press COMPUTER1/2, DVI, HDMI, VIDEO or S-VIDEO on the remote control to select the input mode.

■When you select the input mode with INPUT P/R on the projector or P/R on the remote control:

•When P/R is pressed, the Input list ap- pears. While the Input list is displayed, follow the procedure below to switch the input mode.

–Press P/R to select the desired input mode and then press ENTER.

•When “AUTO SEARCH” is selected, input signal is automatically detected.

•If ENTER is not pressed, the projector switches to the selected input mode in a few seconds.

Note

•When no signal is received, “NO SIGNAL” will be displayed. When non-supported sig- nal is received, “NOT REG.” is displayed.

•The input mode is not displayed when “OSD Display” of the “Options1” menu is set to “Level A” or “Level B”. (See page 57.)

Adjusting the Volume

Press VOL +/– on the projector or on the remote control to adjust the volume.

Note

•Pressing VOL– will lower the volume. Pressing VOL+ will raise the volume.

•When “Pict in Pict” (see page 56) is set to “On”, audio volume cannot be adjusted on the projector. The audio volume buttons will instead function as location shift button for the smaller screen.

'/" buttons

COMPUTER1/2,

DVI, HDMI, VIDEO and S-VIDEO buttons

Input mode menu

Volume buttons

"On-screen display

-36