Sharp XG-P610X, XG-P610X-N 5Checking the Input Signal, 6Auto Sync Adjustment, 7Setting the Auto Sync Display Function, Computer Image Adjustment (“Fine Sync” menu)

Computer Image Adjustment (“Fine Sync” menu)

Menu operation Page 47

5Checking the Input Signal

You can check the input signal information.

6Auto Sync Adjustment

Used to automatically adjust a computer image.

Selectable items	Description
Off	Auto Sync adjustment is not automati-
	cally performed.
Normal	Auto Sync adjustment will occur when
	the projector is turned on or when the
	input signals are switched, when
	connected to a computer.
High Speed
	“Normal” takes more time than “High
	Speed” for more accurate Auto Sync
	adjustment.

Note

•Auto Sync adjustment is also performed by pressing AUTO SYNC on the projector or on the remote control.

•The Auto Sync adjustment may take some time to complete, depending on the image of the computer connected to the projector.

•When the optimum image cannot be achieved with Auto Sync adjustment, use manual adjust- ments. (See page 53.)

•When AUTO SYNC is pressed while “Auto Sync” is “High Speed” or “Off”, Auto Sync will be executed in “High Speed” mode. If the but- ton is pressed again within one minute, Auto Sync will be executed in “Normal” mode.

7Setting the Auto Sync Display Function

Used to set the display during Auto Sync.

Selectable items	Description
Background	The image set as a background image
	is projected. See page 58.
Adjusting Disp.	The computer image being adjusted is
	displayed.

-54