Install the insert as follows:
! WARNING
Insert edges may be SHARP!
Use care when installing.
1.Remove top hinge screw pin
(7/64" Allen wrench, see Figure 15). Remove door by tilting forward and lifting off bottom hinge pin.
UL310
2. Remove two outside screws | Figure 15 | |
holding door handle. Slightly | ||
separate door handle from |
|
|
door (see Figure 16). |
|
|
3. Pull door gasket out of |
|
|
groove (top edge of door |
|
|
only). Start in the middle and |
|
|
pull outward, moving toward |
|
|
the edge (see Figure 17). |
|
|
This may take some force. |
|
|
Do not remove the three |
|
|
screws behind the gasket. |
|
|
4. Pull handle up and off. |
|
|
|
| UL132 |
| Figure 16 | |
| NOTE |
|
Use care not to bend light | ||
switch | bracket | (where |
installed), | located | on door |
bottom when installing door |
insert. Do not set door on bottom edge when pushing insert into place.
5. Slide custom door panel insert into 1/4 inch channel in door front.
UL117
Figure 17
13