U-Line pmn manual Built-In Installation, Initial Start-Up, Unit Dimensions, User’s Manual

User’s Manual

6.Holding door gasket out of the way, replace handle on door mak- ing sure it is seated properly on insert and that screw holes line up.

7.Install two small screws removed in step 2.

8.Starting at the corners and working inward, push door gasket into place on door.

9.Place door on bottom hinge pin and install upper hinge screw.

BUILT-IN INSTALLATION

Your U-Line product has been designed for either free-standing or built- in installation. When built-in, your U-Line product does not require addi- tional air space for top, sides, or rear. However, the front grille must NOT be obstructed.

NOTE

To ease unit installation and removal, it is recommended that the cabinet rough opening dimensions be increased by at least 1/4" over the dimensions given for your unit.

Unit Dimensions

Model	Width	Height	Depth*
2015 Series	14-15/16"	34-1/8"	24"
2075 Series	23-15/16"	34-1/8"	24"

* For full overlay door panels, add 3/4".

INITIAL START-UP

Once installation is complete, the unit is ready for initial start-up and operation.

CONTROL SETTINGS-COMBO/REFRIGERATOR

Models 2015R, 2075R and 2075RF are turned ON with the control knob located on the grille. Turn the knob clockwise for ON, counterclockwise for OFF. Models 2015R, 2075R and 2075RF turn OFF when the temperature control is turned counterclock- wise all the way toward warmer until it stops (until “click” is heard).

4

35

26

17

WARMER COLDER

UL315

Figure 18

14