CONNECTING THE WATER SUPPLY
On Ice Maker models BI 2015 and Combo 2075FF, install a 1/4 inch outside diameter copper water line (not supplied with unit) from the nearest COLD water pipe. When connecting the water supply, follow these guidelines:
•Review the local plumbing codes before you install the unit.
•In most instances, the cold water supply will come from the basement through a hole in the floor.
•The water pressure should be between 15 and 150 psi.
•Install a
•Connect sufficient tubing to the unit to allow the unit to be moved for cleaning and servicing. However, make certain that the tubing is not pinched or damaged during installation.
•
1.Locate the compression fit- 2. Carefully bend the water supply
ting and ferrule packed in the | line into position and connect | ||||
unit. Slide | the compression | the line to the solenoid valve | |||
fitting and ferrule over the | (see Figure 4). Avoid kinking | ||||
1/4 | inch | outside diameter | the water supply line. | ||
water supply line. Do not use |
| ||||
thread sealing compound or |
| ||||
tape. Using two wrenches, |
| ||||
tighten | the | compression fit- | WATER | ||
ting | on | the | supply line (see | ||
CONNECTION | |||||
Figure 3).
UL134 | UL103 |
|
Figure 3
7 
