Regarding the Lamp (Continued)
5
Insert the new lamp unit.
• Press the lamp unit fi rmly into the lamp unit 
compartment. Fasten the securing screw.
6
Replace the lamp unit cover.
• Align the lamp unit cover and slide it to close (1). Then tighten the user service screw (2) to secure the lamp unit cover.
Info
• If the lamp unit and lamp unit cover are not correctly installed, the power will not turn on, even if the power cord is connected to the projector.
Resetting the Lamp Timer
Reset the lamp timer after replacing the lamp.
Info
•Make sure to reset the lamp timer only when replacing the lamp. If you reset the lamp timer and continue to use the same lamp, this may cause the lamp to become damaged or explode.
•You can reset the lamp timer only when “STANDBY mode” is set to “Standard”.
1
Connect the power cord and switch the MAIN POWER switch on the projector to “ON”.
•Plug the power cord into the AC socket of 
the projector.
2Reset the lamp timer.
•The projector enters Standby mode when you reset the lamp timer.
For Lamp 1
•When you reset the timer, press MENU → ENTER → ENTER → MENU → O →
STANDBY/ON on the projector.
•“LAMP1 0000H” is displayed, indicating that the lamp timer is reset.
For Lamp 2
•When you reset the timer, press MENU → ENTER → ENTER → MENU → Q →
STANDBY/ON on the projector.
•“LAMP2 0000H” is displayed, indicating
that the lamp timer is reset.
AC socket
MENU button
O/Q buttons
ENTER button
STANDBY/ON button
68
