Turning the Projector On/Off
Turning the Projector On
Note that the connections to external equipment and power outlet should be done before performing the operations written below. (See pages 21 to 25.)
Remove the lens cap. Then switch the MAIN POWER switch on the projector to “ON” and, after the POWER indicator has turned red, press STANDBY/ON on the projector or on the remote control.
•The POWER indicator illuminates green.
•After the LAMP indicator illuminates, the projector is ready to start operation.
Note
•About the LAMP Indicator
The LAMP indicator illuminates to indicate the status of the lamp. (See page 64 for details.)
Green or orange: The lamp is on.
Blinking in green or orange: The lamp is warming up.
Red: The lamp is shut down abnormally or the lamp should be replaced.
•When you switch on the projector, a slight fl ickering of the image may be experienced within the fi rst minute after the lamp has been illuminated. This is normal operation as the lamp's control circuitry is stabilizing the lamp output characteristics. It should not be regarded as faulty operation.
•If the projector is put into Standby mode and immediately turned on again, the lamp may take some time to start projection.
•When Security Lock is set, the password input box appears. To cancel the password setting, input the password that you have already set. See page 51 for details.
Info
•When “Auto Restart” is set to “On”:
If the power cord is unplugged from the outlet or the breaker switch is turned off when the projector is on, then the projector automatically turns on when the power cord is plugged into the AC outlet or the breaker switch is turned on. (See page 52.)
•English is the factory default language. If you want to change the
STANDBY/ON button
LAMP 1 indicator
LAMP 2 indicator
POWER indicator
STANDBY/ON button
Enter STANDBY Mode?
Yes : Press Again
No : Please Wait
Turning the Power Off (Putting the Projector into Standby Mode)
Press STANDBY/ON on the projector or on the remote control, then press that button again while the confirmation message is displayed, to put the projector into Standby mode.
• The projector cannot be turned on while cooling.
Info
Direct Power Off function:
•You can unplug the power cord or switch the MAIN POWER switch to “OFF” even if the cooling fan is still running.
•If you turn the power back on in the cases shown below, the lamp will take a longer time to light up than usual:
–When the power cord is unplugged during operation
–When the MAIN POWER switch is turned “OFF” during operation
28
