Sharp XG-PH80W-N, XG-PH80X-N, XGPH80XN appendix Attaching the Optional Lens, Lens will be disengaged

Attaching the Optional Lens

When you attach a lens for the first time, skip steps 1 to 3. (When you replace the lens, start from step 1.)

Do not attempt to exchange the lens when the projector is installed hanging from the ceiling. Injury may occur if the lens falls.

1 Press STANDBY/ON on the projector or on the remote control to put the projector into standby mode.

•Switch the MAIN POWER switch on the projector to “OFF”.

•Disconnect the power cord and unplug the power cord from the AC socket after the cooling fan stops.

2 Push the LENS RELEASE button all the way in and turn the lens anti-clockwise.

• The lens will be disengaged.

Note

•If the anti-theft screw is used to secure the lens, the lens cannot be removed when the LENS RELEASE button is pressed. In this case, remove the anti-theft screw fi rst.

STANDBY/ON button

MAIN POWER switch

Power cord

LENS RELEASE button

3

4

Pull the lens out slowly.

Remove the lens cap from a replacement lens.

•Start with this step when you set a lens for the fi rst time.

Info

•If you try to attach the lens to the projector without removing this cap, the optional lens attachment part can be damaged.

26