![](/images/new-backgrounds/1108320/108320157x1.webp)
Problem | Check | Page |
|
|
|
3D images fl icker when | • Images may appear to fl icker when fl uorescent light or ambient light | – |
watching in a room. | enters your vision. |
|
| – Turn off the lights. |
|
| – Block any ambient light. |
|
Ghosting (a double image) | • Check that you are using 3D LCD shutter glasses that support the | – |
occurs without the image | DLP® Link™ system. |
|
appearing in 3D. | – Be sure to use 3D LCD shutter glasses that support the DLP® Link™ |
|
| system. |
|
| • Check that the shutters on the 3D LCD shutter glasses are working | – |
| properly. |
|
| – Turn the 3D LCD shutter glasses off and then on again. |
|
| – Check the batteries of the 3D LCD shutter glasses. |
|
| – Check that the 3D LCD shutter glasses are set to 3D viewing mode. |
|
| Some 3D LCD shutter glasses are equipped with a special viewing |
|
| mode (such as “dual view mode”) in addition to the normal 3D |
|
| viewing mode. See the operation manual of your 3D LCD shutter |
|
| glasses. |
|
|
|
|
| • Check the settings of the projector. | – |
| – Turn the DLP® Link™ function “On”. |
|
| – Use “DLP® Link™ Invert” to change the setting. |
|
| • Check whether a signal that is not supported is being input. | 72 |
| – Confi gure your 3D application at the correct resolution and refresh |
|
| rate. |
|
| Make sure you are running your 3D application in resolutions that |
|
| support 3D. To support 3D, your 3D application must be confi gured |
|
| to run at the correct settings for this projector. |
|
| For details on the supported signals, see “3D Supported Signals” of |
|
| the Compatibility Chart. |
|
| • If the projector is connected to a computer for 3D image playback, | – |
| check that a |
|
| – Use the applicable software. |
|
| – Set the applicable software to the fi eld sequential format. |
|
| • Check that there are no obstructions between the screen and the 3D | – |
| LCD shutter glasses. |
|
| – Remove any obstructions. |
|
| Any obstructions may cause the glasses not to function properly |
|
| causing the lenses to fl icker or turn off. Do not place your hand or |
|
| other objects in front of the 3D control signal sensor on the glasses. |
|
| • Check whether there is a source of high intensity lighting nearby. | – |
| – Block the light or turn it off. |
|
| High intensity lighting can interfere with communication between the |
|
| 3D LCD shutter glasses and the screen resulting in some fl icker. |
|
| • Check whether two or more projectors are projecting 3D images at the | – |
| same time. |
|
| – Use only one projector at a time. |
|
This unit is equipped with a microprocessor. Its performance could be adversely affected by incorrect operation or interference. If this should happen, unplug the Unit and plug it in again after more than 5 minutes.
Appendix
75