Sharp XR-55X, XR-50S appendix Adjusting the Projected Image “SCR-ADJ” Menu, Setting the Resize Mode

Adjusting the Projected Image (“SCR-ADJ” Menu)

Menu operation n Page 39

	Pict.	SIG	SCR-ADJ PRJ1	PRJ2
1	Resize		Normal
2	Image Shift		0
3	Keystone		0
4	Overscan		On
5	OSD Display		On
6	Closed Caption		Off
7	Background		Logo
8	Setup Guide		On
9	PRJ Mode		Front
0	Wall Color		Off
	Language		English
	SEL./ADJ.		ENTER		END

1 Setting the Resize Mode

Use this function to stretch the image vertically or horizontally or when the edges of the image cannot be seen.

Note

•For details of the Resize mode, see pages 30 and 31.

•You can also press RESIZE on the remote control to set the Resize mode. (See page 30.)

3 Keystone Correction

When the image is projected either from the top or from the bottom towards the screen at an angle, the image becomes distorted trapezoidally. The function for correcting trapezoidal distortion is called Keystone Correction.

Select “Keystone” on the “SCR-ADJ” menu and adjust with the slide bar.

See page 28 for details of Keystone Correction.

Q button O button

2 Adjusting the Image

Position

You can move the projected image vertically.

O button Q button

Note

•The Keystone Correction can be adjusted up to an angle of approximately ±40 (XR-55X)/ ±20 (XR-50S) degrees.

•You can also press KEYSTONE on the remote control to adjust Keystone Correction.

Note

•This function only works in some Resize modes. (See pages 30 and 31.)

46