Connecting the Projector to Other Devices

Connecting the Projector to a Computer

Connecting to a Computer Using the the DVI to

15-pin D-sub Adaptor and the RGB Cable

Connect the projector to the computer using the DVI to 15-pin D-sub adaptor and the RGB cable.

•Secure the connectors by tightening the thumbscrews.

Note

•See page 84 “Computer Compatibility Chart” for a list of computer signals com- patible with the projector. Use with com- puter signals other than those listed may cause some of the functions not to work.

•When connecting the projector to a com- puter in this way, select “RGB” for “Signal Type” in the “Options” menu, or select the

RGB mode by pressing on the re- mote control. See page 64.

•A Macintosh adaptor may be required for use with some Macintosh computers. Con- tact your nearest Authorized SharpVision Service Center or Dealer.

•Depending on the computer you are us- ing, an image may not be projected un- less the signal output setting of the com- puter is switched to the external output. Refer to the computer operation manual for switching the computer signal output settings.

Optional

DVI to 15-pin D-sub adaptor

accessory

 

Type: AN-A1DV (7.9" (20cm))

DVI to 15-pin D-sub adaptor

Notebook computer

(sold separately)

To RGB output terminal

RGB Cable (commercially available)

and Connections Setup

-21