Image Projection

Basic Procedure

Connect the required external equipment to the projector before operating the following procedures.

Info

•The language preset at the factory is English. If you want to change the on-screen display to another language, reset the language ac- cording to the procedure on page 34.

1 Plug the power cord into the wall outlet.

•The power indicator illuminates red, and the projector enters standby mode.

2 Press on the remote control or on the projector.

•The power indicator illuminates blue. After the lamp replacement indicator il- luminates, the projector is ready to start operation.

Note

•The lamp replacement indicator il- luminates, indicating the status of the lamp.

Blue: The lamp is ready.

Blue blinking: The lamp is

warming up.

Red: The lamp should be replaced.

•If the power is turned off and imme- diately switched on again, the lamp replacement indicator may take time to illuminate.

•When controlling the projector using RS-232C commands from a com- puter, wait for at least 30 seconds after the power has been turned on, and then transmit the commands.

Lamp replacement indicator

", ',\, buttons

ENTER button

Power (OFF) button

ENTER button

Power indicator

MENU button

INPUT button

Power (OFF) button

Power (ON) button

Power (ON) button

MENU button

', ", \, buttons

INPUT buttons

-32