Sherbourn Technologies PT-7010A owner manual Stop or pause the source

level. Make sure the video can be seen in the TV monitor.

Step 12 - Stop or pause the source.

The PT-7010A now needs to be setup correctly to suit your speakers and system. The SETTINGS (OSD) menu is used to enter and make three main adjustments:

•Speaker Size

•Speaker Calibration

•Speaker Position

This setup needs to be done when you use your system for the first time, or if you change anything such as the amplifiers or speakers, or the speaker position. The calibration is also a good way to check that your system is working correctly. These adjustments are made using the OSD as follows:

Step 13 - Press MENU on the remote to bring up the

28

MAIN Menu of the OSD on your TV.

Step 14 - Use the joystick pad left, right, up and down buttons to navigate through the menus in the next steps.

NOTE: you can quit the OSD at any time by pressing EXIT on the remote. Any changes you make will be saved. There is no need to navigate back through previous pages, unless you want to make more changes.

When the OSD is active, the PT-7010A front panel display shows an abbreviated message of where you currently are in the menus.

Step 15 - In the MAIN Menu, select the SETTINGS Menu, and then the SPEAKERS Menu.

Step 16 - In the SPEAKERS Menu, select the SIZE Menu. Use the joystick pad to set the size of each speaker to Small or Large, or set to OFF for those speakers which are not present. Return to the SPEAKERS Menu when you are finished.

Step 17 - In the SPEAKERS Menu, select the CALIBRATION Menu to adjust the output of each speaker. A test noise plays in each selected speaker, and you use the remote to adjust the volume of each speaker until they are all playing at the same level. Return to the SPEAKERS Menu when you are finished. This task can be made easier and more accurately with a low cost sound level meter. Radio