INPUTS Menu
These menus let you select which input you would like to configure. Pressing the joystick right on each input brings up a second menu which allows you to configure what happens when each input is selected.
Input Configuration Menus (The example shows the
DVD menu)
NAME - Use the joystick up/down, and left/right to change the display name for any input, up to 9 characters. Move fully to the left after entering the name.
whenever the
GAIN TRIM - Use this to adjust all of your sources to play at similar levels. To prevent overloading, the levels can only be adjusted downwards. You should try and trim all the inputs to be the same average level as your quietest source.
DEFAULT MODE - Set the input to a favorite surround mode or stereo.
MAIN ZONE - Enable/disable the selected input in the Main Zone. You can set up your system so any unused inputs are not selectable. From the factory, the inputs are enabled. If you choose to disable an input, then it will not play in the Main Zone.
TRIGGER RELAY - The Trigger Relay can be set to turn on whenever the input is selected. This could be used to turn on an amplifier, video screen, lighting controls, etc.
ZONE 2 - Enable or disable the input for use in Zone 2. Sometimes this is a useful idea to implement when a simple selection is desired in the second zone (such as a patio, play room, garage, or bedroom).
Note: The
Tuner Preset Menu
This allows you to set the AM/FM band and frequency of up to 40 radio stations. They can be recalled quickly and set as favorite stations on the remote control. See page 44.
For FM stations, try to select the
Saving AM/FM Presets
Step 1) Once you are on a preset in the OSD, press the MODE button on the remote control to select the band from FM NR ON, FM NR OFF, or AM MONO.
36