Sherwood R-956 manual Entering a Setup Code, Sherwood MD recorder

ENTERING A SETUP CODE

•This remote control can control up to eight different components.

•Before operating audio and video components using the remote control supplied with this unit, the setup code for each component must be entered.

•For system remote control operation, because “0001” is stored previously in the memory of the component button “AUD” as its factory setup code for this receiver, “0004” in the memory of “AUX” for Sherwood tape deck, “1068” in the memory of “CD” for Sherwood CD player and “0633” in the memory of “DVD” for Sherwood DVD player such as V-756, etc., entering its code for each Sherwood component is not necessary except in case that its code does not work.

However, for Sherwood MD recorder such as MD-7900R, etc., “0005” should be stored in the memory of “AUX” button and for some Sherwood DVD player such as VD-4106, etc., “0591” as a setup code for DVD player should be stored in the memory of “DVD” button.

Note: These codes for Sherwood components, including this receiver, are not listed in “MANUFACTURER’S CODES” in the operating manual of this remote control.

1	Turn on the component you want to				2	Find the setup codes according to the type
	control.					and the brand name of your component,
						referring to “MANUFACTURER’S
						CODES” in the operating manual of this
						remote control.
3	Press the corresponding COMPONENT button.				4	Press and hold down the SETUP button
	Example) When entering “0005” in the					until the LED flickers twice, then release
	memory of “AUX” button for					the SETUP button.
	Sherwood MD recorder.
						T
						SE UP
	For receiver, amplifier￿ : AUD					1	2	3
		1	2	3		7	8	9
	.......					4	5	6
		4	5	6			0
		7	8	9
			0

For tape deck, MD recorder: AUX

	.......
For cable￿	: CBL
	HOME THEATER MASTER
	RNC-30
	HOME THEATER MASTER
	RNC-30

5	Enter the first four-digit code for your						6	Press the POWER button,	1	2	3	PWR
	component.							aiming the remote control	4	5	6
									7	8	9
										0
								at the remote sensor on
								the component.
	For "0005":			1	2	3
				4	5	6
				7	8	9	• Your component will be turned off.
	0	0	0	5	0				HOME THEATER MASTER
										RNC-30
							• If it does not respond, repeat the above steps 2 to 5, trying
							each code for your component until you find one that
							works. If it still does not work, try searching for the code
				HOME THEATER MASTER			using “SEARCHING FOR YOUR CODE” in the
					RNC-30		operating manual of this remote control.
• If entering is performed correctly, the LED will							Notes:
							• If the components do not have a POWER button, press the
flicker twice.							PLAY button.
Note: If the LED did not flicker twice, then repeat the							• Although each setup code is designed to work with many
above steps 3 to 5 and try entering the same							different modes, certain codes may not work with some
code again.							models.(Also, certain codes may only operate some of the
							functions available on a given model.)
							• When operating a Sherwood CD player or tape deck using
	Repeat the above steps 1 to 6 for each of						the system remote control, aim the remote control at the
7							REMOTE SENSOR on this receiver.
	your components.
							However, in case of Sherwood DVD player and MD
							recorder, aim it at the REMOTE SENSOR on the
							corresponding component.

1 3

ENGLISH