Sherwood R-956 manual Entering a video label, Correcting or clearing a video label

ENGLISH

Entering a video label				2	Press the VIDEO LABEL button to enter the
					video label mode.
This function can be operated only on video input					Example) When selecting VIDEO 1.
sources such as VIDEO 1~5.
Select the desired video input source to					VIDEO LABEL
1 enter its label.
	1	2	3
	4	5	6
	7	8	9
VIDEO		0
or	VID SEL
	HOME THEATER MASTER
		RNC-30
Select the character on the flickering digit.					Confirm your selection.
3	MULTI CONTROL			4	VIDEO LABEL

Each time the MULTI CONTROL knob is rotated,		Then the next digit flickers.
the characters change as follows;
		Repeat the above steps 3 and 4 to enter the
Blank (	)
		5 desired characters on the next digits.
Alphabets: A~Z, a~z
Numerals: 0~9		You can enter up to 9 characters for each of the
		video inputs.
Symbols:		Note: If any button such as “AUDIO”, “VIDEO” , “6.1
		CH DIRECT” button, etc. is pressed while entering
		a video label, the video label mode will be
		canceled.

MEMO/ENTER

Memorize the desired video label.

6

Correcting or clearing a video label

Select the desired video input source to be

1 rectified or cleared.

1	2	3
4	5	6
7	8	9
VIDEO	0

or VID SEL

Repeat the steps 2~6 in “Entering a video

2 label” procedure.

To clear a video label, make a blank on each digit and memorize it, then the video label is cleared and its factory video input source will be displayed.

If the VIDEO LABEL button is pressed for more than 3 seconds, blanks will be made on all the digits at once.

HOME THEATER MASTER

RNC-30

3 0