Shindaiwa 68242-94311, EB802RT manual Throttle Control RT, Cruise Function, Throttle Limiter

Throttle Control RT

The RT blower is equipped with a multi- func- tion throttle control. The “Cruise” function allows the operator to use a thumb controlled lever for constant speed use without using the throttle trigger. This is useful for limiting the fatigue caused from holding the throttle for extended periods of time.

Cruise Function

Using the right thumb, push the throttle lock lever down until the desired min-1(RPM) set- ting is reached. See Figure 17.

On the opposite side, a two position “Lim- iter” control allows full engine speed when set for “Turbo” or limits the throttle to a pre-set engine speed when set to low noise (dB) setting.

To bring min-1(RPM) down to idle, push lever back up into original position.

Thumb

Control Lever

Figure 17

Throttle Limiter

The RT blower has a throttle limiter func- tion that allows the operator to pre-set the maximum engine speed. This is useful for reducing the noise emitted by the blower in noise sensitive areas.

Setting Throttle Limiter:

For reduced noise setting, move the throttle limiter located on the right side of the throttle control to the dB setting. See Figure 18.

Throttle Limiter Adjustment

Turbo Setting Turbo

dB

dB Setting

Adjusting Throttle Limiter:

1.Remove the plug located at the top of the throttle assembly. See Figure 19.

2.Move the throttle limiter lever to the “dB” setting. See Figure 19.

3.With the engine running and while depressing the throttle trigger, use a small Phillips screw driver to turn the adjustment screw clockwise to decrease min-1(RPM) and counter-clockwise to increase until desired limited min-1(RPM) is achieved.

4.Reinstall limiter adjustment plug.

Remove limiter adjustment plug

NOTE:

With the throttle limiter adjusted to 3,850 min-1, the RT blower will have a sound level of 65 dB(A) measured at 15m (50 feet) per ANSI B175.2.

Throttle Limiter

Turbo Turbo

Figure 18

Lever

dB

dB

Figure 19

11