Assembly
Trimmer Head C230/T230/T230X
| Remove the | Model | |
| T230 | ||
| retaining |
| |
Holder | plug |
| |
Output | |||
| |||
| Shaft | ||
23019 |
|
| |
Install the
trimmer
head
Figure 16
Shaft Bolt | Model |
Bolt Guard | C230/T230X |
|
Output
Shaft
Holder B 
Holder A
Thread
on the
trimmer
headHolder
B
| Holder |
Figure 17 | A |
|
4.While holding the hex wrench, thread the trimmer head onto the output shaft, turning
5.Using hand pressure only, tighten the trimmer head firmly on the gearshaft.
6.Remove the hex wrench.
7.Adjust the trimmer line length to reach no further than the line cutter on the cutting attachment shield. Trim to the correct length if necessary.
WARNING!
A standard grass trimmer unit with loop handle should NEVER be operated with
Install the Trimmer Head.
1.Turn the unit over so that the gearcase output shaft faces UP.
2.(T230) Remove and discard the plastic retaining plug. See Figure 16.
(T230X/C230) Remove the shaft bolt and bolt guard using the combination spark plug wrench/screwdriver. See Figure 17.
3.Rotate the holder until the hole in the holder aligns with the notch on the gearcase flange. Use the long end of the hex wrench to lock the output shaft in position. See Figure 16 or 17.
IMPORTANT!
The trimmer head has a
the trimmer must be fitted with a bicycle- type handlebar or barrier bar that is lo cated in front of the operator to reduce the risk of the operator coming in contact with the cutting attachment. (Per ANSI B175.3). When using a blade, the unit must be equipped with a harness or strap.
The 230 unit should now be completely assembled and ready for use as a grass trimmer.
Assembly
Blade C230/T230X
Shaft Bolt
Bolt Guard
Holder “B”
Gear Shaft
Safety Clip
Holder “A”
Hex Wrench
Figure 18
Mount the Blade.
Turn the brushcutter upside down so the gearcase output shaft is facing UP, and re- move the shaft bolt, bolt guard and holder B from the gearcase shaft.
1.Align the hole in blade holder “A” with the matching hole in the gearcase flange, and then temporarily lock the
Slide the safety clip
Safety
Clip
Output
Shaft
Figure 19
Slide the saw blade | Center the safety |
in place | clip |
Figure 20 |
|
output shaft by inserting a hex wrench through both holes. See Figure 18.
2.Slide the safety clip
3.Fit the blade over the safety clip and then center it over the flange on holder “A”. See Figure 19.
NOTE:
When installing certain blades, it may be nec- essary to temporarily remove the safety clip.
CAUTION!
Install the blade so its printed surface is visible to the operator when the brushcutter is in the normal operating position.
WARNING!
The blade must fit flat against the holder flange. The blade mounting hole must be centered over the raised boss on blade holder A.
4.Lock the blade in place by centering the safety clip on the output shaft. See Figure 18.
WARNING!
Never operate the brushcutter without the safety clip in place!
10
