Shindaiwa manual Sub-Shield T230X and C230, To Change Position Line Cutter

Assembly

Cutting Attachment Shield All Models

Socket-Head			T230		T230X/C230
Cap Screw				Bolt
	Outer
	Tube		Cutting		Upper Clamp
Bracket			Attachment
			Shield
Shim				Shim
Clamp Screw			Nuts
		Line Cutter		Shim
	Shim			Nut
Retaining	Cutting
	Attachment Shield			Cutting Attachment Shield
Nut
	Mounting Plate		Hex
		Figure 14A
Figure 14			Screws

Install the Cutting Attachment Shield T230/T230X/C230.

1.Insert the cutting attachment shield between the outer tube and the cutting attachment shield mounting plate. See Figure 14.

NOTE:

It may be necessary to loosen the retaining nut and clamp screw to adjust cutting attach- ment shield mounting plate.

2.Fit the two shims and the bracket over the outer tube and loosely install the four socket-head cap screws. See Figure 14.

3.Tighten the four socket-head cap screws to secure the cutting attachment shield.

CAUTION!

Make sure the clamp screw and retaining nut are securely tightened before tighten­ ing the four socket-head cap screws.

WARNING!

NEVER operate the unit without the cutting attachment shield installed and tightly secured!

Sub-Shield T230X and C230.

(when trimmer head is in use)

1.Attach the shield extension to the cutting attachment shield.

WARNING!

NEVER use this machine without sub- shield when using a trimmer head.

Cutting Attachment Shield

Hook

Receiver

Sub-shield Hook

Figure 15

CAUTION!

Make sure the sub-guard is completely hooked at the hook receiver.

To Change Position of

Line Cutter.

The line cutter can be positioned in

2 positions to obtain different line length for cutting.

1.Remove the 2 hex screws with a 4 mm hex wrench. See Figure 14A.

2.Rotate line cutter. See Figure 14A.

3.Reinstall the two hex screws and tighten them securely.

WARNING!

The line cutter is very sharp. Wear gloves to protect your hands when handling.

NOTE:

Be careful to not lose the 2 nuts in the cutting attachment shield, they are not captured.