Manuals / Shindaiwa / Lawn and Garden / Trimmer

Shindaiwa T230 manual Hour Maintenance

Models: T230

1 24

Page 18

135-Hour Maintenance

After every 135 hours of operation or if engine becomes hard to start and has low power. The spark arrester screen should be inspected and cleaned.

WARNING!

Never operate the unit with a damaged or missing muffler or spark arrester! Operating with missing or damaged ex haust components is a fire hazard and could also damage your hearing.

1.Remove the spark plug boot.

2.Remove the engine cover by loosen- ing the engine cover knob (the knob is captive) and lifting the cover from the engine.

3.Remove the spark arrester screen screw.

4.Remove the spark arrester screen and clean with a stiff bristle brush.

IMPORTANT!

If carbon deposits are severe or if no performance improvement is noted, this unit should be inspected by an authorized Shindaiwa servicing dealer.

5.Reassemble the spark arrester screen and engine cover in reverse order.

Figure 39

Engine Cover

Knob

Muffler

Spark Arrestor

Retaining Screw

Spark

Arrester

Screen

23055

Page 18

Image 18

Contents

ENGLISH SHINDAIWA OWNER’S/OPERATOR’S MANUALT230 GRASS TRIMMER T230X GRASS TRIMMER C230 BRUSHCUTTER T230 T230X C230Introduction ContentsGeneral Safety Instructions Attention StatementsGeneral Safety Instructions The Properly Equipped Operator Stay AlertMinimize the Risk of Fire Safety Labels Be Aware of the Working Environment all unitsFEET Specifications Prior to AssemblyUnit Description Connect the Outer Tube to the Powerhead AssemblyDriveshaft/Powerhead All Models HandleAssemble the Handlebar Handlebar C230Throttle Linkage and Ignition Leads All Models Remove the Cylinder CoverRouting of wiring must not interfere with throttle operation Assemble and Adjust the Throttle CableAssembly Throttle Linkage and Ignition Leads All ModelsTo Change Position of Line Cutter Cutting Attachment Shield All ModelsSub-Shield T230X and C230 AssemblyBlade C230/T230X Install the Trimmer HeadTrimmer Head C230/T230/T230X Mount the BladeFilling the Fuel Tank Blade C230/T230X continuedMixing Fuel The C230 Brushcutter should now be completely assembledStopping the Engine When the Engine StartsStarting the Engine 3. Cold Engine Only Set the choke lever to the CLOSED positionOptional Accessories Adjusting Engine IdleIdle Speed Adjustment Using a BladeTrimming and Mowing Grass Using a Grass Trimmer T230Engine Operating Speeds EdgingBrushcutter Handlebar Using A Brushcutter Blade C230/T230XBlade Thrust Brushcutter Harness10-Hour Maintenance General MaintenanceDaily Maintenance MufflerEvery 10 to 15 hours of operation Remove and clean the spark plug 10/15-Hour Maintenance50-Hour Maintenance Every 50 hours of operation135-Hour Maintenance Multiple-tooth Circular Blade Long Term StorageBlade Sharpening Shindaiwa Tornado BladeNO NO Troubleshooting GuideWhat To Check Possible CauseSymptom Troubleshooting Guide continuedADDITIONAL PROBLEMS Possible CauseShindaiwa Corporation Federal Emission Design And Defect Limited WarrantyMAINTENANCE AND REPAIR REQUIREMENTS Utility And Lawn And Garden EnginesPage Telephone Specifications subject to change without noticeShindaiwa Inc 11975 S.W. Herman Rd Tualatin, Oregon 97062 USA Shindaiwa Corporation Head Office 6-2-11, Ozuka-Nishi