CONNECTION OF SPEAKERS
Connection of 4 Speakers
+ I | OPERATE SWITCH | I | I |
MONO O U T | Normally this switch is | SPEAKER | AC O U T L E T |
Monophonic Output | kept to the left (seen | OUTPUT | (SWITCHED) |
Terminals | from behind). | TERMINALS |
There is one set of four speaker output terminals. Use speakers with an impedance of 8 to 16 ohms.
Connection of Speaker Cables
Normal Speaker Connection1. If the bare speaker wire is too short, strip off the vinyl and make the exposed wires the
same length. lomm[318'n1
*F
EXAMPLE: With a speaker terminal on the bottom side.
Remove your finger from the lever, and pull on the cord to be sure that it is properly con- nected.
Put the Operation Switch in the I NORMAL 1 position.
2.Press down the lever and insert the cord. Use a
"+" terminal for the + side of the speaker and a
3.Raise the lever.
Be sure that the wire does not stick out from the cord and come into contact with wire of another cord, as this may damage the equipment.