Shure AVC20 owner manual @ Surround Indicator, Audioivideo Selector, @ Remote Sensor, Bypass

FUNCTION NAMES AND OPERATIONS-FRONT PANEL

Function Names and Operations

@Power Switch (POWER)

Use this switch to turn the power of the AVC20 on and off. After turning on, allow approximately 4 seconds to pass before using. During this time,

the FULL MUTE indicator on the concen- trated indicator panel will flash, indicating that the set is in the stand-by mode.

@Concentrated Indicator Panel

lndicators light up according to the operations performed on the AVC2O.

@SURROUND INDICATOR

Three red LEDs are displayed, depending on the level at the AVMO speaker outputs.

Front Left Channel Front Right Channel

Rear Left Channel Rear Right Channel

@Volume and Balance Controls (For details, refer to page 10)

@Input Selector Switches and lndicators

(AUDIOIVIDEO SELECTOR)

Use these switches to select the program source.

When the WE]switch is pressed, the

..

sound source is switched to the component connected to the TAPE input terminals while the video source is provided by the A-V INPUT whose selector switch is pressed.

(For details, refer to page 18)

@REMOTE SENSOR

This is the window used for receiving the signal from the supplied wireless remote control unit.

BYPASS

Use this position when you wish to obtain stereo sound without any surround effect.

Sound is produced only from the two front speakers.

@SYNTHETIC STEREO

Use this switch to obtain simulated stereo sound from monophonic signals.

Use the SYNTHETIC STEREO vol- ume control located inside the control panel door to adjust the stereo effect.

This function can also be used to expand a stereo source.

@CONCERT SURROUND

This is the best position for viewing televised concerts or old movies.

Use the CONCERT SURROUND volume control located inside the con- trol panel door to adjust the reverbera-

@ SPATIAL time.

SURROUND

I	This is the best position for viewing
	sports or music programs.