Shure AVC20 owner manual Function Names And Operations-Rearpanel, Function Names and Operations

FUNCTION NAMES AND OPERATIONS-REAR PANEL

Function Names and Operations

@A-V INPUT 1 Input/Output Terminals

@A-V INPUT 2 InputIOutput Terminals

A-V INPUT @ and @ Input/Output Terminals are used for connection of components on which recording is possible, such as a video deck.

@A-V INPUT 3 lnput Terminals

A-V INPUT@ lnput Terminals are used for con- nection of components for which only playback is possible, such as video disc players compact disc players, or television tuners.

@PHONO lnput Terminals

PHONO lnput Terminals are used for connection of a Phono Turntable without preamp.

NOTE: Selected input signals (including PHONO and TAPE) appear at output jacks of A-V INPUT 1, A-V INPUT 2 and TAPE.

0 Monitor Output Terminals (MONITOR OUT) These are used for connection to video input terminals of color monito,rs or televisions equipped with video input terminals.

There are two independent output terminals, making possible the connection to two com- ponents.

@Tape Input/Output Terminals (TAPE INIOUT) Connect an audio cassette deck or the like to

these terminals.

(For details, refer to page 18)

@These are front speaker preamplifier output and main amplifier input terminals.

@These are rear speaker preamplifier output and main amplifier input terminals.

Use these for connection of an equalizer or signal processor or of a pre-amplifier or main amplifier other than those of the AVC20.

Usually, use the AVC20 with the pre-amplifier output terminals connected to the main amplifier input terminals with the supplied U- shaped connecting pin.

The AVC20 can also be used in the BTL mode or as a surround processor. For details, refer t o Pages 15 and 17.

@Monophonic output Terminal

MONO OUT A, B

Use these outputs for connection to a Sub- woofer or center channel amplifier and speaker ( A sub-woofer will transduce only low-frequ- ency signals, a full-range speaker will handle the complete audio spectrum.)

The output level is approximately 1V a t a rated input. Match with the input sensitivity of the speaker or other component to be connected.

The output signal of terminals @,) is a mixture of the front left and right channels. When the volume of the front speakers is high, the MONO output level also increases. This can be used as a center channel output.

(For details, refer to page 18).