Issue 03/01 2 Installation
MICROMASTER 411 & COMBIMASTER 411 Operating Instructions
6SE6400-5CA00-0BP0
23
WARNING
♦ This equipment must be grounded.
♦ To ensure safe operation of the equipment, it must be installed and
commissioned by qualified personnel in full compliance with the warnings laid
down in these operating instructions.
♦ Take particular note of the general and regional installation and safety
regulations regarding work on dangerous voltage installations (e.g. EN
50178), as well as the relevant regulations regarding the correct use of tools
and personal protective gear.
♦ The Power supply, DC and motor terminals, can carry dangerous voltages
even if the inverter is inoperative; wait 5 minutes to allow the unit to
discharge after switching off before carrying out any installation work.
4
2.3.1 Preparation
Remove the MICROMASTER 411 installation kit from the packing. Check packing
box contents against the advice note supplied.
The installation kit should comprise the following items:
1. Inverter cover
2. Terminal Housing
3. Filter Module & screws (captive)
4. Input – Output Board & screws (captive)
5. Earth Lead
6. 10 Off Terminal Jumpers
7. Getting Started Guide and CD
8. 2 off Glands M25 IP68 withO-ring
9. 2 off M25 sealing plugs
10. 2 off M25 Gland Fixing Plates
11. 2 off U-clamp & screws (for earth/ground connection)
12. 4 off M4 Inverter to Motor fixing screws
(CSC only: additional 4 off M5 screws)
13. Motor Cable Sheath
14. 1 off Motor Gasket (CSC only: additional 1 off Motor Gasket)
15. 1 off M12 connector blanking plug
Any defective or missing items should be reported immediately to your local
Siemens Distributor or Sales Office.