Internet - ADSL Settings
Enable ADSL Port:
Check this box to enable this function. It simply invokes the line mode that you choose here for the router.
Select the support of line modes: There are several selections for your choosing. Select the one that you need. For Example, if you want to change one or more physical layer parameters while the
Capability Enabled:
Two items are provided here for you to choose.
Bitswap:
It is a mandatory receiver initiated feature to maintain the operating conditions of the modem during changing environment conditions. It reallocates the data bits and power among the allowed carriers without modification of the higher layer control parameters in the ATU. After a bit swapping reconfiguration, the total data rate and the data rate on each latency path is unchanged. Check this box to enable the function. If not, uncheck this box to close the function.
Seamless Rate Adaptation:
It enables the ADSL2 system to change the data rate of the connection while in operation without any service interruption or bit errors. Check this box to enable the function. If not, uncheck this box to close the function.
IP Routing - Static Route
Routing Table shows all static route status and allows you to add new static IP route or delete IP route. A Static IP Routing is a manually defined path, which determines the data transmitting route. If your local network is composed of multiple subnets, you may want to specify a routing path to the routing table.
Destination Network Address:
Display the IP address that the data packets are to be sent.
Netmask:
Display the subnet mask that the data transmitting is passing through.
Gateway:
Display the gateway that the data transmitting is passing through.
WAN Interface:
Display the interface that the data transmitting is passing through.
Delete:
